The blind spot monitor sensor receives yaw rate signals from the airbag sensor assembly (yaw rate and acceleration sensor) via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A46 | Yaw Rate Sensor | A fail flag is transmitted from the airbag sensor assembly (yaw rate and acceleration sensor) | ·
Vehicle stability control system ·
Blind spot monitor sensor LH ·
Blind spot monitor sensor RH |
When checking for DTCs, make sure that the blind spot monitor system is turned on.
Check for vehicle stability control system DTCs.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
Vehicle stability control system DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch off.
Turn the ignition switch to ON.
Recheck for DTCs and check if the same DTC is output again.
| Result | Proceed to |
|---|---|
| No DTCs are output. | A |
| DTC C1A46 is output ("Blind Spot Monitor Master"). | B |
| DTC C1A46 is output ("Blind Spot Monitor Slave"). | C |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C