This DTC is stored when the destination information of the main body ECU (multiplex network body ECU) does not match that of the blind spot monitor sensors.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U1331 | Software Incompatibility with Body Control Module "B" | Destination information of the main body ECU and blind spot monitor sensor do not match | ·
Main body ECU (multiplex network body ECU) ·
Blind spot monitor sensor LH ·
Blind spot monitor sensor RH |
When checking for DTCs, make sure that the blind spot monitor system is on.
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.*
*: w/ Smart Entry and Start System
Check the main body ECU (multiplex network body ECU) part number.
Check if the part number of the main body ECU (multiplex network body ECU) installed on the vehicle is correct.
The part number is correct.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs and check if the same DTC is output again.
| Result | Proceed to |
|---|---|
| No DTCs are output | A |
| DTC U1331 is output ("Blind Spot Monitor Master") | B |
| DTC U1331 is output ("Blind Spot Monitor Slave") | C |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C