Home › Engine / Hybrid System › 2GR-FKS (ENGINE CONTROL) › ECM › from 2016.11
RM3160E _51 Engine / Hybrid System _060156 2GR-FKS ENGINE CONTROL _0303254 ECM A

2GR-FKS ENGINE CONTROL  ECM  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

Perform Vehicle Identification Number (VIN) registration when replacing the ECM.

Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>SFI SYSTEM>REGISTRATION

·

If the ECM has been struck or dropped, replace it.

·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

Before replacing the ECM, refer to Service Bulletin.



Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 53299D 3.REMOVE RADIATOR SIDE DEFLECTOR SEAL LH

Hide 53298E 4.REMOVE RADIATOR SIDE SEAL RH

Hide 53295E 5.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 17750A 6.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 7.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

Hide 89661 8.REMOVE ECM

a.
A394307

Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.

NOTICE:

After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.



b.
A394306

Disengage the clamp and separate the wire harness.


c.
A394308

Remove the 3 bolts and ECM.

NOTICE:

If the ECM has been struck or dropped, replace it.



Hide 89667 9.REMOVE ECM BRACKET

a.
A394309

Remove the 2 screws and ECM bracket from the ECM.


Hide 89668 10.REMOVE NO. 2 ECM BRACKET

a.
A394310

Remove the 2 screws and No. 2 ECM bracket from the ECM.