Home › Engine / Hybrid System › 2GR-FKS STARTING › STARTER › from 2016.11
RM3160E _51 Engine / Hybrid System _060163 2GR-FKS STARTING _0300110 STARTER A

2GR-FKS STARTING  STARTER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 53299D 3.REMOVE RADIATOR SIDE DEFLECTOR SEAL LH

Hide 53298E 4.REMOVE RADIATOR SIDE SEAL RH

Hide 53295E 5.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 11209 6.REMOVE V-BANK COVER SUB-ASSEMBLY

Hide 17750A 8.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 17700 9.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

Hide 28100 10.REMOVE STARTER ASSEMBLY

a.
A170648

Disconnect the starter assembly connector.


b.

Open the terminal cap.


c.

Remove the nut and disconnect terminal 30.


d.
A170649

Type A:

i.

Remove the 2 bolts and starter assembly.



e.
A395141

Type B:

i.

Remove the 2 nuts and the starter assembly.


ii.

Using an E8 "TORX" socket wrench, remove the 2 stud bolts from the automatic transaxle assembly.