1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE FRONT WHEEL LH
51441
4.REMOVE NO. 1 ENGINE UNDER COVER
53737B
5.REMOVE FRONT FENDER APRON SEAL LH
6.DRAIN ENGINE COOLANT
53299D
7.REMOVE RADIATOR SIDE DEFLECTOR SEAL LH
53298E
8.REMOVE RADIATOR SIDE SEAL RH
53295E
9.REMOVE COOL AIR INTAKE DUCT SEAL
17750A
10.REMOVE INLET AIR CLEANER ASSEMBLY
17700
11.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
28800
12.REMOVE BATTERY
16281K
13.DISCONNECT NO. 4 WATER BY-PASS HOSE
Slide the clip and disconnect the No. 4 water by-pass hose from the transmission oil cooler.
Use a container to catch any coolant which flows out of the No. 4 water by-pass hose and transmission oil cooler.
16267H
14.DISCONNECT NO. 3 WATER BY-PASS HOSE
Slide the clip and disconnect the No. 3 water by-pass hose from the transmission oil cooler.
Use a container to catch any coolant which flows out of the No. 3 water by-pass hose and transmission oil cooler.
15.DISCONNECT INLET NO. 2 OIL COOLER HOSE
Slide the clip and disconnect the inlet No. 2 oil cooler hose from the transmission oil cooler.
Use a container to catch any automatic transaxle fluid which flows out of the inlet No. 2 oil cooler hose and transmission oil cooler.
16.DISCONNECT OUTLET NO. 3 OIL COOLER HOSE
Slide the clip and disconnect the outlet No. 3 oil cooler hose from the transmission oil cooler.
Use a container to catch any automatic transaxle fluid which flows out of the outlet No. 3 oil cooler hose and transmission oil cooler.
32942
17.DISCONNECT OUTLET NO. 1 OIL COOLER HOSE
| *1 | Transmission Oil Cooler Tube Clamp |
Remove the transmission oil cooler tube clamp.
Slide the clip and disconnect the outlet No. 1 oil cooler hose from the No. 1 oil cooler tube sub-assembly without hose.
32943
18.DISCONNECT NO. 1 TRANSMISSION OIL COOLER HOSE
Slide the clip and disconnect the No. 1 transmission oil cooler hose from the oil cooler union sub-assembly.
32907C
19.REMOVE NO. 1 OIL COOLER TUBE SUB-ASSEMBLY WITHOUT HOSE
| *1 | Inlet No. 1 Oil Cooler Hose |
Slide the clip and disconnect the inlet No. 1 oil cooler hose from the connector tube.
Use a container to catch any automatic transaxle fluid which flows out of the inlet No. 1 oil cooler hose and connector tube.
Remove the 2 bolts and No. 1 oil cooler tube sub-assembly without hose from the automatic transaxle case sub-assembly and engine mounting bracket LH.
| *1 | No. 1 Oil Cooler Tube Sub-assembly without Hose |
| *2 | Inlet No. 1 Oil Cooler Hose |
| *3 | Inlet No. 2 Oil Cooler Hose |
| *4 | Outlet No. 3 Oil Cooler Hose |
Slide the 3 clips and remove the inlet No. 1 oil cooler hose, inlet No. 2 oil cooler hose and outlet No. 3 oil cooler hose from the No. 1 oil cooler tube sub-assembly without hose.
33493A
20.REMOVE TRANSMISSION OIL COOLER
Remove the 3 bolts.
Disengage the hook to remove the transmission oil cooler from the automatic transaxle case sub-assembly.
Use a container to catch any coolant and automatic transaxle fluid which flows out of the transmission oil cooler.
32971
21.REMOVE TRANSMISSION OIL THERMOSTAT
| *1 | No. 1 Transmission Oil Cooler Hose |
| *2 | Outlet No. 1 Oil Cooler Hose |
Slide the 2 clips and remove the No. 1 transmission oil cooler hose and outlet No. 1 oil cooler hose from the transmission oil thermostat.
Use a container to catch any automatic transaxle fluid which flows out of the transmission oil thermostat, No. 1 transmission oil cooler hose and outlet No. 1 oil cooler hose.
| *1 | No. 2 Transmission Oil Cooler Hose |
| *2 | Outlet No. 2 Oil Cooler Hose |
Slide the 2 clips and disconnect the No. 2 transmission oil cooler hose and outlet No. 2 oil cooler hose from the transmission oil thermostat.
Use a container to catch any automatic transaxle fluid which flows out of the transmission oil thermostat, No. 2 transmission oil cooler hose and outlet No. 2 oil cooler hose.
Remove the bolt and transmission oil thermostat from the oil cooler stay.
Use a container to catch any automatic transaxle fluid which flows out of the transmission oil thermostat.