Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB › from 2018.09
RM3160E _52 Drivetrain _019687 AXLE AND DIFFERENTIAL _0109439 REAR AXLE HUB A

AXLE AND DIFFERENTIAL  REAR AXLE HUB  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 42312B 2.REMOVE REAR AXLE SHAFT NUT (for AWD)

a.
C293042

Using SST and a hammer, release the staked part of the rear axle shaft nut.

SST
09930-00010  

NOTICE:

Loosen the staked part of the rear axle shaft nut completely, otherwise the threads of the rear drive shaft assembly may be damaged.



b.
C293043

While applying the parking brakes, remove the rear axle shaft nut.


Hide 3.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

Hide 42491 4.REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG

Hide 42431 5.REMOVE REAR DISC

Hide 89516B 6.SEPARATE SKID CONTROL SENSOR WIRE (for 2WD)

Hide 89546 7.SEPARATE REAR SPEED SENSOR (for AWD)

a.
C293840

Remove the bolt and separate the rear speed sensor from the rear axle carrier sub-assembly.

NOTICE:
·

Prevent foreign matter from contacting the sensor tip.

·

Clean the rear speed sensor installation hole and the contact surfaces every time the rear speed sensor is removed.

·

Be careful not to damage the rear speed sensor.




Hide 42450B 8.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY (for 2WD)

a.
C293046

Remove the 4 bolts and rear axle hub and bearing assembly from the rear axle carrier sub-assembly.


Hide 42440 9.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY (for AWD)

a.
C293044C01
3.177,1.521 3.177,0.375 3.177,0.375 2.875,0.375 true 3.021,0.708 3.167,0.708 true 3.083,1.531 3.396,1.688 0.313,0.156 10 false *a
*a Matchmark


Put matchmarks on the rear drive shaft assembly and rear axle hub and bearing assembly.


b.
C293045

Using a plastic hammer, separate the rear drive shaft assembly from the rear axle hub and bearing assembly.

HINT:

If it is difficult to separate the rear drive shaft assembly from the rear axle hub and bearing assembly, tap the end of the rear drive shaft assembly using a brass bar and a hammer.



c.
C293047

Remove the 4 bolts and rear axle hub and bearing assembly from the rear axle carrier sub-assembly.