CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
| *A | Main Body ECU (Multiplex Network Body ECU) with 2 Connectors | - | - |
| *1 | Main Body ECU (Multiplex Network Body ECU) | - | - |
| *a | 2 connectors | - | - |
| *A | Main Body ECU (Multiplex Network Body ECU) with 3 Connectors | - | - |
| *1 | Main Body ECU (Multiplex Network Body ECU) | - | - |
| *a | 3 connectors | - | - |
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
Reconnect the instrument panel junction block assembly connectors.
Measure the resistance and voltage according to the value(s) in the table below.
Measure the values on the wire harness side with the connector disconnected.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| MB-11 (GND1) - Body ground | - | Ground | Always | Below 1 Ω |
| MB-31 (BECU) - Body ground | - | Battery power supply | Always | 11 to 14 V |
| MB-30 (ACC) - Body ground | - | ACC power supply | Ignition switch ACC | 11 to 14 V |
| MB-30 (ACC) - Body ground | - | ACC power supply | Ignition switch off | Below 1 V |
| MB-32 (IG) - Body ground | - | IG power supply | Ignition switch ON | 11 to 14 V |
| MB-32 (IG) - Body ground | - | IG power supply | Ignition switch off | Below 1 V |
Install the main body ECU (multiplex network body ECU) to instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>INSTALLATION
Measure the voltage and check for pulses according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| 4H-10 (ACT-) - Body ground | LA-P - Body ground | Door lock motor unlock drive output (all doors) | Door control switch or driver door key cylinder off | Below 1 V |
| 4H-10 (ACT-) - Body ground | LA-P - Body ground | Door lock motor unlock drive output (all doors) | Door control switch or driver door key cylinder unlocked | 11 to 14 V |
| 4D-3 (ACT-) - Body ground | G - Body ground | Door lock motor unlock drive output (all doors) | Door control switch or driver door key cylinder off | Below 1 V |
| 4D-3 (ACT-) - Body ground | G - Body ground | Door lock motor unlock drive output (all doors) | Door control switch or driver door key cylinder unlocked | 11 to 14 V |
| 4H-12 (ACT+) - Body ground | LA-L - Body ground | Door lock motor lock drive output (except driver door) | Door control switch or driver door key cylinder off | Below 1 V |
| 4H-12 (ACT+) - Body ground | LA-L - Body ground | Door lock motor lock drive output (except driver door) | Door control switch or driver door key cylinder locked | 11 to 14 V |
| 4D-1 (ACT+) - Body ground | LA-R - Body ground | Door lock motor lock drive output (except driver door) | Door control switch or driver door key cylinder off | Below 1 V |
| 4D-1 (ACT+) - Body ground | LA-R - Body ground | Door lock motor lock drive output (except driver door) | Door control switch or driver door key cylinder locked | 11 to 14 V |
| 4D-2 (ACTD) - Body ground | BE - Body ground*2
B - Body ground*3 |
Door lock motor lock drive output (for driver door) | Door control switch or driver door key cylinder off | Below 1 V |
| 4D-2 (ACTD) - Body ground | BE - Body ground*2
B - Body ground*3 |
Door lock motor lock drive output (for driver door) | Door control switch or driver door key cylinder locked | 11 to 14 V |
| F19-27 (FRCY) - Body ground | L - Body ground | Front door courtesy light switch assembly (for RH) input | Front door RH open | Below 1 V |
| F19-27 (FRCY) - Body ground | L - Body ground | Front door courtesy light switch assembly (for RH) input | Front door RH closed | 11 to 14 V or Pulse generation |
| F19-6 (FLCY) - Body ground | SB - Body ground | Front door courtesy light switch assembly (for LH) input | Front door LH open | Below 1 V |
| F19-6 (FLCY) - Body ground | SB - Body ground | Front door courtesy light switch assembly (for LH) input | Front door LH closed | 11 to 14 V or Pulse generation |
| 4H-36 (LCTY) - Body ground | SB - Body ground | Rear door courtesy light switch assembly (for LH) input | Rear door LH open | Below 1 V |
| 4H-36 (LCTY) - Body ground | SB - Body ground | Rear door courtesy light switch assembly (for LH) input | Rear door LH closed | 11 to 14 V or Pulse generation |
| 4D-30 (RCTY) - Body ground | LG - Body ground | Rear door courtesy light switch assembly (for RH) input | Rear door RH open | Below 1 V |
| 4D-30 (RCTY) - Body ground | LG - Body ground | Rear door courtesy light switch assembly (for RH) input | Rear door RH closed | 11 to 14 V or Pulse generation |
| 4D-10 (LSFL) - Body ground | GR - Body ground | Front door LH unlock detection switch input | Front door LH unlocked | Below 1 V |
| 4D-10 (LSFL) - Body ground | GR - Body ground | Front door LH unlock detection switch input | Front door LH locked | 11 to 14 V or Pulse generation |
| 4D-26 (LSFR) - Body ground | Y - Body ground | Front door RH unlock detection switch input | Front door RH unlocked | Below 1 V |
| 4D-26 (LSFR) - Body ground | Y - Body ground | Front door RH unlock detection switch input | Front door RH locked | 11 to 14 V or Pulse generation |
| F18-2 (LSWR) - Body ground | LG - Body ground | Rear door RH unlock detection switch input | Rear door RH unlocked | Below 1 V |
| F18-2 (LSWR) - Body ground | LG - Body ground | Rear door RH unlock detection switch input | Rear door RH locked | 11 to 14 V or Pulse generation |
| 4H-34 (LSWL) - Body ground | V - Body ground | Rear door LH unlock detection switch input | Rear door LH unlocked | Below 1 V |
| 4H-34 (LSWL) - Body ground | V - Body ground | Rear door LH unlock detection switch input | Rear door LH locked | 11 to 14 V or Pulse generation |
| 4H-33 (BCTY) - Body ground | LA-Y - Body ground | Back door courtesy light switch input | Back door open | Below 1 V |
| 4H-33 (BCTY) - Body ground | LA-Y - Body ground | Back door courtesy light switch input | Back door closed | 11 to 14 V or Pulse generation |
| 4H-4 (TR+) - Body ground | LA-SB - Body ground | Back door lock motor unlock drive output | Back door opener switch pushed | 11 to 14 V |
| 4H-4 (TR+) - Body ground | LA-SB - Body ground | Back door lock motor unlock drive output | Back door opener switch not pushed | Below 1 V |
| 4D-28 (KSW) - Body ground | GR - Body ground | Key unlock warning switch input | No key in ignition key cylinder | 11 to 14 V or Pulse generation |
| 4D-28 (KSW) - Body ground | GR - Body ground | Key unlock warning switch input | Key in ignition key cylinder | Below 1 V |
| 4F-30 (BZR) - Body ground*1 | B - Body ground | Wireless door lock buzzer signal | Wireless door lock buzzer off | Below 1 V |
| 4F-30 (BZR) - Body ground*1 | B - Body ground | Wireless door lock buzzer signal | Wireless door lock buzzer on | Pulse generation |
| F19-5 (PRG) - Body ground | B - Body ground | Signal output to door control receiver | Key inserted into ignition key cylinder → Key pulled out of ignition key cylinder | 11 to 14 V → Pulse generation → 11 to 14 V |
| F19-4 (RDA) - Body ground | LG - Body ground | Signal input from door control receiver | Ignition switch off, all doors closed and door control transmitter module set sub-assembly switch not pressed | 11 to 14 V |
| Ignition switch off, all doors closed and door control transmitter module set sub-assembly switch pressed | Pulse generation |
*1: w/ Wireless Door Lock Buzzer Answer-back Function
*2: for LHD
*3: for RHD