The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during outer rear view mirror assembly with cover removal/installation are shown below.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
67492A
1.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
2.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
3.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
69278B
4.REMOVE FRONT DOOR INSIDE HANDLE BEZEL
81230N
5.REMOVE COURTESY LIGHT ASSEMBLY
67602
6.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
87964
7.REMOVE OUTER MIRROR INSTALL HOLE COVER
Disengage the 2 clamps.
Remove the screw.
Disengage the 3 claws to remove the outer mirror install hole cover.
8.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER
Disengage the clamp.
| *A | w/o Memory | *B | w/ Memory |
| *C | w/ Panoramic View Monitor System | - | - |
Disconnect each connector.
Remove the 3 nuts.
Disengage the claw and 2 guides to remove the outer rear view mirror assembly with cover.