Home › Engine / Hybrid System › 2GR-FKS (EMISSION CONTROL) › EMISSION CONTROL SYSTEM
RM37A0E _51 Engine / Hybrid System _086853 2GR-FKS EMISSION CONTROL _0416578 EMISSION CONTROL SYSTEM G

2GR-FKS EMISSION CONTROL  EMISSION CONTROL SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:
A345137

To prevent injury due to contact with an operating V-ribbed belt or cooling fan, keep your hands and clothing away from the V-ribbed belt and cooling fans when working in the engine compartment with the engine running or the ignition switch ON.


PROCEDURE

Hide 1.INSPECT FUEL CUT OPERATION

CAUTION:

To prevent injury due to contact with an operating V-ribbed belt or cooling fan, keep your hands and clothing away from the V-ribbed belt and cooling fans when working in the engine compartment with the engine running or the ignition switch ON.


a.

Start the engine.


b.

Warm up the engine.


c.

Increase the engine speed to approximately 3500 rpm.


d.

Use a sound scope to check for fuel injector assembly operating sounds.


e.

When the accelerator pedal is fully released, check that fuel injector assembly operating sounds stop momentarily and then resume.

Standard:
Item Specified Condition
Fuel cut permission engine speed 2500 rpm or higher
Fuel injection restart engine speed 1400 rpm


If the result is not as specified, check the fuel injector assemblies, wire harness and ECM.


Hide 2.VISUALLY CHECK HOSES, CONNECTIONS AND GASKETS

a.

Visually check that the hoses, connections and gaskets have no cracks, leaks or damage.

NOTICE:
·

Detachment or other problems with the engine oil level dipstick, oil filler cap sub-assembly, ventilation hose or other components may cause the engine to run improperly.

·

Air suction caused by disconnections, looseness or cracks in any part of the air induction system between the throttle body with motor assembly and cylinder head sub-assembly will cause engine failure or engine malfunctions.



If any defects are found, replace parts as necessary.


Hide 3.INSPECT EVAPORATIVE EMISSION CONTROL SYSTEM

CAUTION:

To prevent injury due to contact with an operating V-ribbed belt or cooling fan, keep your hands and clothing away from the V-ribbed belt and cooling fans when working in the engine compartment with the engine running or the ignition switch ON.


a.

Start the engine.


b.
A457779

Slide the clip and disconnect the fuel vapor feed hose from the purge valve (purge VSV).


c.

Check that vacuum occurs at the purge valve (purge VSV) port.

Powertrain > Engine > Active Test
Tester Display
Activate the EVAP Purge VSV
50004 372 1

d.

If vacuum does not occur, check the following items.

·

Purge valve (purge VSV)

·

Clogging in the No. 1 fuel vapor feed hose that connects the intake air surge tank assembly and purge valve (purge VSV)



e.

Exit Active Test mode and connect the fuel vapor feed hose to the purge valve (purge VSV) and slide the clip to secure it.

If the result is not as specified, replace the purge valve (purge VSV), wire harness or ECM.

Click hereEngine / Hybrid System>2GR-FKS (EMISSION CONTROL)>PURGE VALVE>INSTALLATION


f.

Warm up the engine and drive the vehicle.


g.

Confirm that the purge valve (purge VSV) opens.

Powertrain > Engine > Data List
Tester Display
EVAP (Purge) VSV
50003 372 226

If the result is not as specified, replace the purge valve (purge VSV), wire harness or ECM.