Home › Vehicle Exterior › WINDOW / GLASS › WINDSHIELD DEICER SYSTEM › 2020.02–2020.11
RM37A0E _59 Vehicle Exterior _086899 WINDOW / GLASS _0416696 WINDSHIELD DEICER SYSTEM J

WINDOW / GLASS  WINDSHIELD DEICER SYSTEM  Windshield Deicer does not Operate  


DESCRIPTION

When the front wiper deicer switch is operated, the operation signal is transmitted to the air conditioning amplifier assembly directly. When the air conditioning amplifier assembly receives the signal, it turns on the DEICER relay to operate the windshield deicer system.

WIRING DIAGRAM

B567697E02
2.135,2.729 3.281,2.938 1.146,0.208 10 false ECU-IG1 NO. 3 2.417,3.281 2.979,3.5 0.563,0.219 10 false DEICER 0.479,2.552 1.906,2.792 1.427,0.24 10 false from IG1-NO. 1 Relay 0.458,3.125 2.073,3.396 1.615,0.271 10 false from Auxiliary Battery 0.729,6.26 2.615,6.5 1.885,0.24 10 false : LIN Communication Line 5.219,6.208 6.76,6.677 1.542,0.469 10 false Air Conditioning Amplifier Assembly 2.781,1.521 4.979,1.906 2.198,0.385 10 false Front Wiper Deicer Switch (Air Conditioning Control Assembly) 5.479,2.479 6.01,2.698 0.531,0.219 10 false FDEF 5.479,5.479 6.01,5.698 0.531,0.219 10 false GND 2.896,5.406 4.354,5.813 1.458,0.406 10 false Windshield Deicer Wire (Windshield Glass) 3.219,3.448 3.781,3.667 0.563,0.219 10 false DEICER 2.979,4.208 3.51,4.427 0.531,0.219 10 false E 3.99,4.219 4.521,4.438 0.531,0.219 10 false B 3.927,4.635 4.458,4.854 0.531,0.219 10 false B2 5.479,0.792 6.01,1.01 0.531,0.219 10 false LIN1 3.604,0.802 4.135,1.021 0.531,0.219 10 false LIN1 5.313,0.625 5.844,0.844 0.531,0.219 10 false 7 3.969,0.656 4.573,0.885 0.604,0.229 10 false 8 5.24,5.385 5.771,5.604 0.531,0.219 10 false 17 3.073,2.458 3.604,2.677 0.531,0.219 10 false 2 3.771,2.458 4.302,2.677 0.531,0.219 10 false 1 3.76,3.042 4.292,3.26 0.531,0.219 10 false 5 3.094,3.052 3.625,3.271 0.531,0.219 10 false 3 4.156,4.219 4.688,4.438 0.531,0.219 10 false 1 4.167,4.635 4.698,4.854 0.531,0.219 10 false 3 2.823,4.208 3.354,4.427 0.531,0.219 10 false 2 5.24,2.469 5.771,2.688 0.531,0.219 10 false 22 5.229,6.021 5.76,6.24 0.531,0.219 10 false H62 2.906,5.24 3.438,5.458 0.531,0.219 10 false A60 2.792,1.354 3.396,1.583 0.604,0.229 10 false H27


CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses for circuits related to this system before performing the following procedure.

·

If the auxiliary battery voltage becomes low, auxiliary battery load control will operate in order to ensure sufficient power is supplied to the power steering system. In this case, the windshield deicer system may not operate.

·

The windshield deicer system uses the CAN communication system. First, confirm that there are no malfunctions in the CAN communication system. Refer to How to Proceed with Troubleshooting.

Click hereVehicle Exterior>WINDOW / GLASS>WINDSHIELD DEICER SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING



PROCEDURE

1.CHECK AIR CONDITIONING SYSTEM
a.

Check that the air conditioning system can be operated using the remote touch.

HINT:

Both the windshield deicer system operation signal and air conditioning system operation signal are transmitted to the air conditioning amplifier assembly through same communication line.


OK:

The air conditioning system operates normally.



Result:
Proceed to
OK
NG



OK

2.PERFORM ACTIVE TEST USING GTS

NG

2.PERFORM ACTIVE TEST USING GTS
a.

Perform the Active Test according to the display on the GTS.

Body Electrical > Air Conditioner > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Deicer Relay (Front) Windshield deicer wire (windshield glass) OFF or ON -
Body Electrical > Air Conditioner > Active Test
Tester Display
Deicer Relay (Front)
50004 121 38
OK:

The windshield deicer system operates normally.



Result:
Proceed to
OK
NG



OK

3.REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

4.INSPECT DEICER RELAY
3.REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY
a.

Replace the air conditioning amplifier assembly with a new or known good one.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER>REMOVAL


b.

Check that the windshield deicer system operates normally.

OK:

The windshield deicer system operates normally.


Result:
Proceed to
OK
NG




OK

END (AIR CONDITIONING AMPLIFIER ASSEMBLY WAS DEFECTIVE)

NG

REPLACE AIR CONDITIONING CONTROL ASSEMBLY

4.INSPECT DEICER RELAY
a.
E209082

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω
3 - 5 Auxiliary battery voltage not applied between terminals 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

5.CHECK WIRE HARNESS AND CONNECTOR (DEICER RELAY - POWER SUPPLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5.CHECK WIRE HARNESS AND CONNECTOR (DEICER RELAY - POWER SUPPLY)
a.
B567930C01
0.208,0.198 0.552,0.417 0.344,0.219 10 false *a
*a DEICER Relay Holder


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
DEICER relay holder terminal 2 - Body ground Ignition switch ON 11 to 14 V
DEICER relay holder terminal 3 - Body ground Ignition switch off*1
Always*2
11 to 14 V


*1: for HV Model

*2: for Gasoline Model



Result:
Proceed to
OK
NG



OK

6.CHECK WIRE HARNESS AND CONNECTOR (DEICER RELAY - AIR CONDITIONING AMPLIFIER ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

6.CHECK WIRE HARNESS AND CONNECTOR (DEICER RELAY - AIR CONDITIONING AMPLIFIER ASSEMBLY)
a.
B567930C01
0.208,0.198 0.552,0.417 0.344,0.219 10 false *a
*a DEICER Relay Holder


Disconnect the H62 air conditioning amplifier assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
DEICER relay holder terminal 1 - H62-22 (FDEF) Always Below 1 Ω
DEICER relay holder terminal 1 or H62-22 (FDEF) - Body ground Always 10 kΩ higher



Result:
Proceed to
OK
NG



OK

7.CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

7.CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
a.

Reconnect the H62 air conditioning amplifier assembly connector.


b.
B567681C01
1.677,0.229 2.063,0.49 0.385,0.26 1.219,1.844 1.375,1.844 1.375,1.844 1.375,1.073 true 2.083,1.885 1.885,1.885 1.885,1.885 1.885,1.156 true 1.74,0.281 2.094,0.51 0.354,0.229 10 false H62 2.125,1.813 2.583,2.01 0.458,0.198 10 false FDEF 0.896,1.75 1.354,1.948 0.458,0.198 10 false GND 0.125,0.115 0.583,0.313 0.458,0.198 10 false *a
*a Component with harness connected
(Air Conditioning Amplifier Assembly)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
H62-22 (FDEF) - H62-17 (GND) Ignition switch ON, Front wiper deicer switch on Below 1 V
H62-22 (FDEF) - H62-17 (GND) Ignition switch ON, Front wiper deicer switch off 11 to 14 V



Result:
Proceed to
OK
NG



OK

8.CHECK WIRE HARNESS AND CONNECTOR (DEICER RELAY - WINDSHIELD DEICER WIRE (WINDSHIELD GLASS))

NG

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

8.CHECK WIRE HARNESS AND CONNECTOR (DEICER RELAY - WINDSHIELD DEICER WIRE (WINDSHIELD GLASS))
a.
B567930C01
0.208,0.198 0.552,0.417 0.344,0.219 10 false *a
*a DEICER Relay Holder


Disconnect the A60 windshield deicer wire (windshield glass) connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
DEICER relay holder terminal 5 - A60-1 (B) Always Below 1 Ω
DEICER relay holder terminal 5 - A60-3 (B2) Always Below 1 Ω
A60-1 (B) - Body ground Always 10 kΩ higher
A60-3 (B2) - Body ground Always 10 kΩ higher
DEICER relay holder terminal 5 - Body ground Always 10 kΩ higher



Result:
Proceed to
OK
NG



OK

9.CHECK WIRE HARNESS AND CONNECTOR (WINDSHIELD DEICER WIRE (WINDSHIELD GLASS) - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

9.CHECK WIRE HARNESS AND CONNECTOR (WINDSHIELD DEICER WIRE (WINDSHIELD GLASS) - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A60-2 (E) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

REPLACE WINDSHIELD DEICER WIRE (WINDSHIELD GLASS)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR