Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM
RM37A0E _58 Vehicle Interior _086889 METER / GAUGE / DISPLAY _0416706 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Engine Coolant Temperature Receiver Gauge Malfunction  


DESCRIPTION

In this circuit, the combination meter assembly receives engine coolant temperature signals from the ECM via CAN communication. The combination meter assembly displays an engine coolant temperature warning based on the data received from the ECM.

WIRING DIAGRAM

E370855E20
0.677,2.271 3.042,2.521 2.365,0.25 10 false : CAN Communication Line 1.656,1.563 3.208,2.115 1.552,0.552 10 false ECM 4.677,1.563 6.656,1.969 1.979,0.406 10 false Combination Meter Assembly

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

·

Before replacing the ECM, refer to Service Bulletin.*

*: for Gasoline Model




PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

2.CHECK FOR DTC (SFI SYSTEM)

B

2.CHECK FOR DTC (SFI SYSTEM)
a.

Check if SFI system DTCs are output.

Powertrain > Engine > Trouble Codes
50001 372

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

3.PERFORM ACTIVE TEST USING GTS

B

3.PERFORM ACTIVE TEST USING GTS
a.

Perform the Active Test according to the display on the GTS.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Water Temperature Meter Operation (50C,122F) Engine coolant temperature receiver gauge
(50°C, 122°F)
ON See [Display 1]
Water Temperature Meter Operation (60C,140F) Engine coolant temperature receiver gauge
(60°C, 140°F)
ON See [Display 1]
Water Temperature Meter Operation (70C,158F) Engine coolant temperature receiver gauge
(70°C, 158°F)
ON See [Display 1]
Water Temperature Meter Operation (80C,176F) Engine coolant temperature receiver gauge
(80°C, 176°F)
ON See [Display 1]
Water Temperature Meter Operation (Middle) Engine coolant temperature receiver gauge
(Middle)
ON See [Display 1]
Water Temperature Meter Operation (110C,230F) Engine coolant temperature receiver gauge
(110°C, 230°F)
ON See [Display 1]
Water Temperature Meter Operation (120C,248F) Engine coolant temperature receiver gauge
(120°C, 248°F)
ON See [Display 1]
Water Temperature Meter Operation (127C,260F) Engine coolant temperature receiver gauge
(127°C, 260°F)
ON See [Display 1]
[Display 1]: Water Temperature Meter Operation
E430493C01
2.583,0.656 1.396,0.677 false 1.875,1.698 1.396,0.688 false 1.01,1.708 1.396,0.677 false 2.594,0.938 1.396,0.688 false 2.458,1.438 1.396,0.677 false 0.688,1.5 1.385,0.677 false 1.448,1.76 1.396,0.688 false 0.948,1.719 1.146,1.885 0.198,0.167 10 false 2 1.417,1.792 1.646,2.031 0.229,0.24 10 false 3 1.896,1.708 2.115,1.896 0.219,0.188 10 false 4 0.594,1.49 0.844,1.688 0.25,0.198 10 false 1 2.521,1.375 2.677,1.573 0.156,0.198 10 false 5 2.656,0.875 2.813,1.073 0.156,0.198 10 false 6 2.646,0.563 2.802,0.76 0.156,0.198 10 false 7 0.083,0.073 0.396,0.271 0.313,0.198 10 false *a
*a Engine Coolant Temperature Receiver Gauge


HINT:

Refer to the following table for the specified engine coolant temperature receiver gauge position for each selected value:

Tester Display Engine Coolant Temperature Receiver Gauge Indication
Water Temperature Meter Operation
(50C, 122F)
Approximately 1 is indicated*1
Between 1 and 2 is indicated*2
Water Temperature Meter Operation
(60C, 140F)
Approximately 1 is indicated*1
Between 2 and 3 is indicated*2
Water Temperature Meter Operation
(70C, 158F)
Approximately 1 is indicated*1
Between 3 and 4 is indicated*2
Water Temperature Meter Operation
(80C, 176F)
Between 2 and 3 is indicated*1
Between 3 and 4 is indicated*2
Water Temperature Meter Operation
(Middle)
Between 3 and 4 is indicated
Water Temperature Meter Operation
(110C, 230F)
Between 4 and 5 is indicated
Water Temperature Meter Operation
(120C, 248F)
Approximately 6 is indicated
Water Temperature Meter Operation
(127C, 260F)
Approximately 7 is indicated

*1: for HV Model

*2: for Gasoline Model




Body Electrical > Combination Meter > Active Test
Tester Display
Water Temperature Meter Operation (50C,122F)
50004 409 236
Body Electrical > Combination Meter > Active Test
Tester Display
Water Temperature Meter Operation (60C,140F)
50004 409 237
Body Electrical > Combination Meter > Active Test
Tester Display
Water Temperature Meter Operation (70C,158F)
50004 409 238
Body Electrical > Combination Meter > Active Test
Tester Display
Water Temperature Meter Operation (80C,176F)
50004 409 239
Body Electrical > Combination Meter > Active Test
Tester Display
Water Temperature Meter Operation (Middle)
50004 409 240
Body Electrical > Combination Meter > Active Test
Tester Display
Water Temperature Meter Operation (110C,230F)
50004 409 241
Body Electrical > Combination Meter > Active Test
Tester Display
Water Temperature Meter Operation (120C,248F)
50004 409 242
Body Electrical > Combination Meter > Active Test
Tester Display
Water Temperature Meter Operation (127C,260F)
50004 409 243
OK:

Engine coolant temperature receiver gauge operation is normal.



Result:
Proceed to
OK
NG



OK

NG

REPLACE COMBINATION METER ASSEMBLY