1.REMOVE FRONT DOOR VENT SEAL
Remove the 2 front door vent seals.
2.REMOVE INNER ROOF SIDE SEAL (for Panoramic Moon Roof)
Remove the inner roof side seal.
86101D
3.REMOVE NO. 3 ANTENNA CORD SUB-ASSEMBLY (for Normal Roof)
86101D
4.REMOVE NO. 3 ANTENNA CORD SUB-ASSEMBLY (for Moon Roof)
86101D
5.REMOVE NO. 3 ANTENNA CORD SUB-ASSEMBLY (for Panoramic Moon Roof)
6.REMOVE REAR WASHER HOSE ASSEMBLY
for Normal Roof:
Remove the adhesive tape from the roof headlining assembly.
| *A | w/ Adhesive Tape | - | - |
|
Adhesive Tape | - | - |
for Moon Roof:
Remove the adhesive tape from the roof headlining assembly.
| *A | w/ Adhesive Tape | - | - |
|
Adhesive Tape | - | - |
for Panoramic Moon Roof:
Remove the adhesive tape from the roof headlining assembly.
| *A | w/ Adhesive Tape | - | - |
|
Adhesive Tape | - | - |
Remove the rear washer hose assembly from the roof headlining assembly.
81390C
7.REMOVE SPOT LIGHT ASSEMBLY LH (for Panoramic Moon Roof)
81360K
8.REMOVE SPOT LIGHT ASSEMBLY RH (for Panoramic Moon Roof)
Use the same procedure as for the LH side.
9.REMOVE NO. 3 ROOF HEADLINING SUPPORT (except Panoramic Moon Roof)
Remove the No. 3 roof headlining support.
82171
10.REMOVE NO. 1 ROOF WIRE (for Normal Roof)
Remove the adhesive tape from the roof headlining assembly.
|
Adhesive Tape | - | - |
Turn the 2 visor connectors counterclockwise approximately 45° and remove them from the roof headlining assembly.
| *a | 45° | - | - |
|
Rotation Direction | - | - |
Disengage each clamp.
Remove the No. 1 roof wire from the roof headlining assembly.
82171
11.REMOVE NO. 1 ROOF WIRE (for Moon Roof)
Remove the adhesive tape from the roof headlining assembly.
|
Adhesive Tape | - | - |
Turn the 2 visor connectors counterclockwise approximately 45° and remove them from the roof headlining assembly.
| *a | 45° | - | - |
|
Rotation Direction | - | - |
Disengage each clamp.
Remove the No. 1 roof wire from the roof headlining assembly.
82171
12.REMOVE NO. 1 ROOF WIRE (for Panoramic Moon Roof)
Remove the adhesive tape from the roof headlining assembly.
|
Adhesive Tape | - | - |
Turn the 2 visor connectors counterclockwise approximately 45° and remove them from the roof headlining assembly.
| *a | 45° | - | - |
|
Rotation Direction | - | - |
Disengage each clamp.
Remove the No. 1 roof wire from the roof headlining assembly.