Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER
RM37A0E _53 Suspension _086866 REAR SUSPENSION _0417437 REAR SHOCK ABSORBER A

REAR SUSPENSION  REAR SHOCK ABSORBER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear shock absorber assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement)
·

Measurement of ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking Support Brake System (Click here)
Rear television camera assembly optical axis (Back camera position setting) Parking Assist Monitor System (Click here)
·

Parking assist ECU initialization

·

Adjust steering angle


Panoramic View Monitor System (Click here)

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 48738 2.REMOVE REAR SUSPENSION ARM COVER

Hide 48540 3.REMOVE REAR SHOCK ABSORBER ASSEMBLY

a.
C426681C01
1.781,1.74 2.229,1.74 true 1.969,2.146 2.208,2.146 false 2.281,1.656 2.5,1.833 0.219,0.177 10 true *a 2.313,2.063 2.625,2.219 0.313,0.156 10 false *b
*a Wooden Block
*b Jack
V100155

Wooden Block Placement Location


Using a jack and wooden block, support the rear No. 2 suspension arm assembly.

NOTICE:
·

When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.

·

Make sure to perform this operation with the vehicle kept as low as possible.

·

Keep supporting the rear No. 2 suspension arm assembly with a jack until the installation of the rear shock absorber assembly has been completed.




b.
C426682

Remove the 2 bolts, nut and the rear shock absorber assembly from the vehicle.


Hide 48517 4.REMOVE REAR UPPER SHOCK ABSORBER BRACKET

HINT:

Perform this procedure only when replacement of the rear upper shock absorber bracket is necessary.


a.
C426683

Remove the 3 nuts, and the rear upper shock absorber bracket from the vehicle.