Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER
RM37A0E _53 Suspension _086866 REAR SUSPENSION _0417437 REAR SHOCK ABSORBER A

REAR SUSPENSION  REAR SHOCK ABSORBER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 48517 1.INSTALL REAR UPPER SHOCK ABSORBER BRACKET

HINT:

Perform this procedure only when replacement of the rear upper shock absorber bracket is necessary.


a.

Install the rear upper shock absorber bracket to the vehicle with the 3 nuts.

Torque:
68 N*m (693 kgf*cm, 50 ft.*lbf)


Hide 48540 2.TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY

a.
C427617C01
1.781,2.688 1.781,2.083 true 1.719,2.708 2.031,2.948 0.313,0.24 10 false *a
*a Protector


Temporarily install the rear shock absorber assembly with the 2 bolts and nut.

NOTICE:
·

Ensure that the protector faces the front of the vehicle.

·

Insert the bolt with the threaded end facing the rear of the vehicle.

·

Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.




Hide 3.STABILIZE SUSPENSION

a.
C426684C01
1.521,1.854 1.865,1.854 false 0.646,2.052 0.927,2.052 false 1.906,1.771 2.219,1.927 0.313,0.156 10 false *a 0.479,1.958 0.792,2.115 0.313,0.156 10 false *b 0.156,1.313 0.333,1.5 0.177,0.188 10 true A
*a Wooden Block
*b Jack
V100155

Wooden Block Placement Location


Using a jack and wooden block, apply load to the suspension so that the rear No. 2 suspension arm assembly is positioned as shown in the illustration.

Standard Length (A):

19.5 mm (0.768 in.)


CAUTION:

Do not jack up the rear No. 2 suspension arm assembly too high as the vehicle may fall.


NOTICE:
·

When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.

·

Make sure to perform this operation with the vehicle kept as low as possible.




Hide 48540 4.INSTALL REAR SHOCK ABSORBER ASSEMBLY

a.
C427749N01
0.656,1.021 0.813,1.208 0.156,0.188 10 true A 1.094,3.01 1.25,3.198 0.156,0.188 10 false B

Install the rear shock absorber assembly with the bolt (A) and bolt (B).

Torque:
Bolt (A) : 90 N*m (918 kgf*cm, 66 ft.*lbf)
Bolt (B) : 85 N*m (867 kgf*cm, 63 ft.*lbf)

NOTICE:

Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.



Hide 48738 5.INSTALL REAR SUSPENSION ARM COVER

Hide 6.INSTALL REAR WHEEL

Hide 7.PERFORM INITIALIZATION

Parking Support Brake System (Click here)
Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)