Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
85035
1.INSTALL WASHER NOZZLE SUB-ASSEMBLY (w/o Heater)
Connect a new washer nozzle sub-assembly to the washer hose.
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Engage the 2 claws as indicated by the arrows, in the order shown in the illustration to install the washer nozzle sub-assembly.
85380
2.INSTALL FRONT WASHER NOZZLE AND HOSE ASSEMBLY (w/ Heater)
Tie the string that was passed through the hood sub-assembly to the wire harness of a new front washer nozzle and hose assembly.
Pass the wire harness of the front washer nozzle and hose assembly through the hood sub-assembly.
Remove the string from the wire harness of the front washer nozzle and hose assembly.
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Engage the 2 claws as indicated by the arrows, in the order shown in the illustration to install the front washer nozzle and hose assembly.
Connect the washer hose.
Connect the connector.
85035
3.INSPECT WASHER NOZZLE SUB-ASSEMBLY
85035
4.ADJUST WASHER NOZZLE SUB-ASSEMBLY
53341B
5.INSTALL HOOD INSULATOR (w/ Heater)