Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER MOTOR
RM37A0E _59 Vehicle Exterior _086901 WIPER / WASHER _0417573 HEADLIGHT CLEANER MOTOR A

WIPER / WASHER  HEADLIGHT CLEANER MOTOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during headlight cleaner motor and pump assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link

*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.

Front bumper assembly*
·

Measurement of ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking Support Brake System (Click here)
Front television camera view adjustment Panoramic View Monitor System (Click here)
Replacement or removal and installation of 2 or more parts:
·

Front television camera assembly, radiator grille sub-assembly or front bumper assembly

·

Rear television camera assembly

·

Side television camera assembly LH or outer rear view mirror assembly LH

·

Side television camera assembly RH or outer rear view mirror assembly RH


Television camera view adjustment Panoramic View Monitor System (Click here)

Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link

*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.

Front bumper assembly*
·

Measurement of ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking Support Brake System (Click here)
Front television camera view adjustment Panoramic View Monitor System (Click here)
Replacement or removal and installation of 2 or more parts:
·

Front television camera assembly, radiator grille sub-assembly or front bumper assembly

·

Rear television camera assembly

·

Side television camera assembly LH or outer rear view mirror assembly LH

·

Side television camera assembly RH or outer rear view mirror assembly RH


Television camera view adjustment Panoramic View Monitor System (Click here)

PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 2.DRAIN WASHER FLUID

a.
E435542C01
0,0 0,0 false
V113147

Disconnect in this Direction


Loosen the clip as shown in the illustration.

HINT:

Use a container to collect the washer fluid.



b.

Disconnect the headlight cleaner hose from the headlight cleaner motor and pump assembly, and drain the washer fluid.


Hide 85280A 3.REMOVE HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY

a.
E435543C01
0,0 0,0 false
V113147

Remove in this Direction


Disconnect the connector.


b.

Remove the headlight cleaner motor and pump assembly as shown in the illustration.