Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
75602A
1.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY
61668C
2.REMOVE NO. 2 QUARTER PANEL SEAL
75860A
3.REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY
Apply protective tape around the body rocker panel moulding assembly and doors as shown in the illustration.
|
Protective Tape | - | - |
Remove the 9 clips and 2 screws.
Disengage the 8 clips to remove the body rocker panel moulding assembly.
Remove the 8 clips from the body rocker panel moulding assembly.