Home › Engine / Hybrid System › A25A-FXS, A25B-FXS (FUEL) › FUEL PUMP (for High Pressure)
RM37A0E _51 Engine / Hybrid System _086907 A25A-FXS, A25B-FXS FUEL _0417788 FUEL PUMP(for High Pressure) G

A25A-FXS, A25B-FXS FUEL  FUEL PUMP(for High Pressure)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1. FUEL PUMP ASSEMBLY OPERATION

a.

Check fuel pressure.

i.

Put the engine in Inspection Mode (Maintenance Mode).

Powertrain > Hybrid Control > Utility
Tester Display
Inspection Mode
50005 397 2103

ii.

Start the engine.


iii.

Check that the fuel pressure fluctuates when the target fuel pressure changes.

Powertrain > Engine > Active Test
Active Test Display
Control the Target Fuel Pressure Offset
Data List Display
Fuel Pressure (High)
50004 372 6 265
HINT:

The target fuel pressure operation decreases the target fuel pressure by 12.5% or increases the target fuel pressure by 24.8%.


If the result is not as specified, replace the fuel pump assembly or fuel pressure sensor.



b.

Check operating sound.

i.

ii.

Start the engine.


iii.

Using a sound scope, check the operating sound of the fuel pump assembly.

If no sound can be heard, check the fuel pump assembly, wire harness and ECM.


iv.

Stop the engine.


v.