Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER
RM37A0E _56 Audio / Visual / Telematics _086877 AUDIO / VIDEO _0417842 NOISE FILTER A

AUDIO / VIDEO  NOISE FILTER  REMOVAL  


PROCEDURE

Hide 1.REMOVE REAR NO. 2 SEAT ASSEMBLY

Hide 58387B 2.REMOVE REAR FLOOR FINISH PLATE

Hide 72138M 3.REMOVE REAR OUTER SEAT TRACK BRACKET COVER LH

Hide 67918A 4.REMOVE REAR DOOR SCUFF PLATE LH

Hide 62332C 5.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH

Hide 64713F 6.REMOVE FRONT DECK SIDE TRIM COVER LH

Hide 64715E 7.REMOVE NO. 2 DECK SIDE TRIM COVER

Hide 64974 8.REMOVE DECK TRIM POCKET COVER

Hide 64725F 9.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

Hide 64740C 11.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

Hide 86011V 12.REMOVE RADIO SETTING CONDENSER

NOTICE:

When a terminal cover is removed, the radio setting condenser must be replaced because the terminal covers and condenser are supplied as a set.


a.
E431109

Remove the bolt.


b.

Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.


c.
E365954C04
0,0 0,0 false
V113147

Remove in this Direction


Disengage the claw and pull out the cover as shown in the illustration.


d.
E368797C01
0,0 0,0 false
V113147

Remove in this Direction


Using a screwdriver, disengage the 6 claws and remove the 2 terminal covers with wire harness from the condenser as shown in the illustration.


e.
E223708

Using a screwdriver, bend back and break off the claw as shown in the illustration.

HINT:

Use the same procedure for the other terminal cover.



f.

Remove the 2 terminal covers from the wire harness.

NOTICE:
·

Make sure to hold the crimped side of the terminal when disconnecting the wire harness from the terminal cover.

·

Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

·

Check for deformation of the terminal after the wire harness has been removed from the terminal cover.