86011V
1.INSTALL RADIO SETTING CONDENSER
Engage the claw to install a new terminal cover to the wire harness.
Make sure to hold the crimped side of the terminal when installing the wire harness to the terminal cover.
Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.
Do not use excessive force when inserting the wire harness into the terminal cover.
If the terminal cover has been deformed during installation, replace the terminal and terminal cover with new ones.
Use the same procedure for the other terminal cover.
|
Install in this Direction |
Engage the 6 claws to install 2 new terminal covers with wire harness to a new condenser as shown in the illustration.
Do not use excessive force when inserting the terminal covers into the condenser.
If a terminal cover has been deformed during installation, replace the terminal, terminal covers and condenser with new ones.
|
Install in this Direction |
Insert the cover as shown in the illustration and engage the claw.
Engage the clamp to temporarily install the new radio setting condenser with wire harness.
Install the new radio setting condenser with the bolt.
64740C
2.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
66311
3.INSTALL ROPE HOOK
64725F
4.INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
64974
5.INSTALL DECK TRIM POCKET COVER
64715E
6.INSTALL NO. 2 DECK SIDE TRIM COVER
64713F
7.INSTALL FRONT DECK SIDE TRIM COVER LH
62332C
8.CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
67918A
9.INSTALL REAR DOOR SCUFF PLATE LH
72138M
10.INSTALL REAR OUTER SEAT TRACK BRACKET COVER LH
58387B
11.INSTALL REAR FLOOR FINISH PLATE
12.INSTALL REAR NO. 2 SEAT ASSEMBLY