The steering pad switch assembly outputs the dynamic cruise control on/off signal and various control signals to the ECM.
The ECM controls the dynamic cruise control system according to the signals received from the steering pad switch assembly.
Before replacing the ECM, refer to Service Bulletin.
The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Cancel Switch | CANCEL switch status | OFF or ON | OFF: CANCEL switch not pushed
ON: CANCEL switch pushed |
- |
| -SET Switch | -SET switch status | OFF or ON | OFF: -SET switch not pushed
ON: -SET switch pushed |
- |
| +RES Switch | +RES switch status | OFF or ON | OFF: +RES switch not pushed
ON: +RES switch pushed |
- |
| Cruise Main Switch Operation Condition | Cruise control main switch status | OFF or ON | OFF: Cruise control main switch not pushed
ON: Cruise control main switch pushed |
- |
| Tester Display |
|---|
| Cancel Switch |
| -SET Switch |
| +RES Switch |
| Cruise Main Switch Operation Condition |
The value of each Data List item changes according to the operation of the steering pad switch assembly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the steering pad switch assembly.
Click hereSteering>STEERING COLUMN>STEERING PAD SWITCH>REMOVAL
Inspect the steering pad switch assembly.
Click hereSteering>STEERING COLUMN>STEERING PAD SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the spiral cable sub-assembly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL
Inspect the spiral cable sub-assembly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the A28 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H24-13 (CCS) - A28-41 (CCS) | Always | Below 1 Ω |
| H24-2 (ECC) - Body ground | Always | Below 1 Ω |
| H24-13 (CCS) or A28-41 (CCS) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG