The forward recognition camera receives the vehicle information from the hybrid vehicle control ECU via CAN communication.
DTC U030057 is stored when the vehicle information from the hybrid vehicle control ECU and that stored in the forward recognition camera do not match.
The forward recognition camera receives the vehicle information from the ECM via CAN communication.
DTC U030057 is stored when the vehicle information from the ECM and that stored in the forward recognition camera do not match.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U030057 | Internal Control Module Software Incompatibility Invalid / Incompatible Software Component | for HV Model
The vehicle information from the hybrid vehicle control ECU and that stored in the forward recognition camera do not match. for Gasoline Model
The vehicle information from the ECM and that stored in the forward recognition camera do not match. |
for HV Model
·
Hybrid control system ·
Forward recognition camera ·
Hybrid vehicle control ECU for Gasoline Model
·
SFI system ·
Forward recognition camera ·
ECM |
Before replacing the hybrid vehicle control ECU, refer to Service Bulletin.*1
Before replacing the ECM, refer to Service Bulletin.*2
When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.
If the forward recognition camera has been replaced with a new one, be sure to perform forward recognition camera adjustment.
Forward recognition camera adjustment can be performed by using either One Time Recognition or Sequential Recognition.
One Time Recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (ONE TIME RECOGNITION)
Sequential Recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (SEQUENTIAL RECOGNITION)
*1: for HV Model
*2: for Gasoline Model
Choose the model to be inspected.
| Result | Proceed to |
|---|---|
| for HV Model | A |
| for Gasoline Model | B |
A
B
Check for DTCs of hybrid control system.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
for 2WD: Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for 2WD)>HOW TO PROCEED WITH TROUBLESHOOTING
for 4WD/AWD: Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for 4WD/AWD)>HOW TO PROCEED WITH TROUBLESHOOTING
Check for DTCs.
Turn the ignition switch off.
DTCs indicating a vehicle information mismatch with that of the hybrid vehicle control ECU are not output by any ECU other than the forward recognition camera.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| HV Equipped Information | Vehicle information (conventional/hybrid) stored in forward recognition camera | Non-HV / HV | Non-HV: Conventional vehicle
HV: Hybrid vehicle |
- |
| Tester Display |
|---|
| HV Equipped Information |
If the vehicle information stored in the forward recognition camera is different from the actual vehicle specifications, the vehicle information stored in the forward recognition camera may be incorrect. Replace the forward recognition camera.
If the vehicle information stored in the forward recognition camera matches the actual vehicle specifications, the installed hybrid vehicle control ECU is incompatible. Replace the hybrid vehicle control ECU.
| Result | Proceed to |
|---|---|
| Vehicle information stored in forward recognition camera and actual vehicle specifications do not match | A |
| Vehicle information stored in forward recognition camera and actual vehicle specifications match | B |
A
B
Check for DTCs of SFI system.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Check for DTCs.
Turn the ignition switch off.
DTCs indicating a vehicle information mismatch with that of the ECM are not output by any ECU other than the forward recognition camera.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| HV Equipped Information | Vehicle information (conventional/hybrid) stored in forward recognition camera | Non-HV / HV | Non-HV: Conventional vehicle
HV: Hybrid vehicle |
- |
| Tester Display |
|---|
| HV Equipped Information |
If the vehicle information stored in the forward recognition camera is different from the actual vehicle specifications, the vehicle information stored in the forward recognition camera may be incorrect. Replace the forward recognition camera.
If the vehicle information stored in the forward recognition camera matches the actual vehicle specifications, the installed ECM is incompatible. Replace the ECM.
| Result | Proceed to |
|---|---|
| Vehicle information stored in forward recognition camera and actual vehicle specifications do not match | A |
| Vehicle information stored in forward recognition camera and actual vehicle specifications match | B |
A
B