Home › Engine / Hybrid System › 2GR-FKS (ENGINE CONTROL) › ACTIVE CONTROL ENGINE MOUNT › 2020.02–2020.11
RM37A0E _51 Engine / Hybrid System _086849 2GR-FKS ENGINE CONTROL _0418439 ACTIVE CONTROL ENGINE MOUNT A

2GR-FKS ENGINE CONTROL  ACTIVE CONTROL ENGINE MOUNT  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front engine mounting insulator removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Learning can also be performed using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 17650E 2.REMOVE VACUUM SWITCHING VALVE (for Active Control Engine Mount System)

Hide 53852B 3.REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

Hide 53851D 4.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

Hide 51441 5.REMOVE NO. 1 ENGINE UNDER COVER

Hide 51444A 6.REMOVE REAR ENGINE UNDER COVER LH

Hide 7.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

Hide 12361 8.REMOVE FRONT ENGINE MOUNTING INSULATOR

a.
A454768

Disengage the 4 wire harness clamps.


b.

Remove the bolt and separate the engine wire.


c.
A454766

Rotate the lever while pushing the lock, and disconnect the ECM connector.

NOTICE:

After disconnecting the ECM connector, make sure that dirt, water and other foreign matter does not contact the connecting parts of the ECM connector.



d.
A454769

Rotate the lever while pushing the lock, and disconnect the transmission wire connector.


e.
A454771

Remove the 2 bolts.


f.
A454772

Support the engine assembly with transaxle using a jack and wooden block.


g.
A454773

Remove the 4 bolts and front engine mounting bracket.


h.
A454774

Remove the 3 nuts and front engine mounting insulator from the front frame assembly.


i.
A454775

Disconnect the vacuum hose from the front engine mounting insulator.


j.

Disengage the clamp to remove the vacuum hose from the front engine mounting insulator.