The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission wire removal/installation are shown below.
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
12361
1.REMOVE FRONT ENGINE MOUNTING INSULATOR
53737B
2.REMOVE FRONT FENDER APRON SEAL LH
3.DRAIN AUTOMATIC TRANSAXLE FLUID
Remove the refill plug and gasket from the automatic transaxle case sub-assembly.
Using a 10 mm hexagon socket wrench, remove the overflow plug and gasket from the transaxle housing.
| *1 | No. 1 Transmission Oil Filler Tube |
Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler tube from the transaxle housing and drain the automatic transaxle fluid.
Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube to the transaxle housing.
Using a 10 mm hexagon socket wrench, temporarily install the gasket and overflow plug to the transaxle housing.
Reuse the old gasket as the overflow plug will be removed again to adjust the automatic transaxle fluid level.
Temporarily install the gasket and refill plug to avoid automatic transaxle fluid spillage.
Reuse the old gasket as the refill plug will be removed again to adjust the automatic transaxle fluid level.
32942
4.DISCONNECT OUTLET NO. 1 OIL COOLER HOSE
Slide the clip and disconnect the outlet No. 1 oil cooler hose from the oil cooler union sub-assembly.
32901C
5.REMOVE OIL COOLER UNION SUB-ASSEMBLY
| *1 | Oil Cooler Union Bolt |
| *2 | Gasket |
Remove the bolt, oil cooler union bolt, 2 gaskets and oil cooler union sub-assembly from the automatic transaxle case sub-assembly.
35151F
6.REMOVE TRANSMISSION CASE SIDE COVER
Remove the 10 bolts and transmission case side cover from the automatic transaxle case sub-assembly.
82125J
7.REMOVE TRANSMISSION WIRE
| *a | Connector (A) |
| *b | Connector (B) |
Disengage the clamp to disconnect the transmission wire from the solenoid lock plate.
Disconnect the 9 solenoid valve connectors.
Using a screwdriver, disconnect the solenoid valve connector (A) using the procedure shown in the illustration.
Using a screwdriver, disconnect the solenoid valve connector (B) using the procedure shown in the illustration.
Remove the bolt and temperature sensor clamp and separate the temperature sensor from the transmission valve body assembly.
Disconnect the transmission revolution sensor (NT) connector and transmission revolution sensor (NC) connector.
Remove the bolt and transmission wire from the automatic transaxle case sub-assembly.