Home › Vehicle Exterior › DOOR / HATCH › HOOD › 2020.02–2020.11
RM37A0E _59 Vehicle Exterior _086885 DOOR / HATCH _0418595 HOOD N

DOOR / HATCH  HOOD  ADJUSTMENT  


CAUTION / NOTICE / HINT

B563248C01
0.75,0.177 1.063,0.333 0.313,0.156 10 false *a 2.521,0.177 2.833,0.333 0.313,0.156 10 false *b
*a Centering Bolt
*b Standard Bolt


HINT:
·

Centering bolts are used to install the hood hinges and hood lock. The hood and hood lock cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts (with washers) when making adjustments.

·

The specified torque for standard bolts is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 53301 1.INSPECT HOOD SUB-ASSEMBLY

Hide 53301 2.ADJUST HOOD SUB-ASSEMBLY

a.

Horizontally and vertically adjust the hood.

i.
B563249

Loosen the 4 hinge bolts of the hood.


ii.

Adjust the clearance between the hood and front fenders by moving the hood.


iii.

Tighten the 4 hinge bolts after adjustment.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)



b.

Adjust the height of the front end of the hood using the hood bumper cushions.

i.
B563250

Adjust the 2 hood bumper cushions so that the heights of the hood and fenders are aligned.

HINT:

Raise or lower the front end of the hood by turning the 2 hood bumper cushions.




c.

Adjust the hood lock.

i.

Remove the cool air intake duct seal.

Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER>REMOVAL


ii.
B563251C01
1.354,1.885 1.51,1.26 true 1.25,1.885 1.448,2.073 0.198,0.188 10 true *a
*a Protective Tape


Using a screwdriver with its tip wrapped with protective tape, remove the hood lock nut cap.


iii.
B563253C01
1.781,1.5 2.427,1.688 true 2.448,1.573 2.719,1.75 0.271,0.177 10 true *1
*1 Hood Lock Bolt


Loosen the 2 bolts and hood lock bolt.


iv.
B563254C01
1.76,1.49 2.427,1.688 true 2.438,1.604 2.708,1.781 0.271,0.177 10 true *1
*1 Hood Lock Bolt


Adjust the hood lock assembly and tighten the 2 bolts and hood lock bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


v.

Check that the striker can engage the hood lock assembly smoothly.


vi.
B563252

Install a new hood lock nut cap.


vii.

Install the cool air intake duct seal.

Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER>INSTALLATION