When SNOW mode is selected, the operation of the throttle motor is moderated to control engine output. This helps to reduce skidding of the drive wheels, and assists with takeoff acceleration, driving straightness and turning stability.
Read the value displayed on the GTS.
| Tester Display |
|---|
| Snow Mode SW |
| Condition | GTS Display (Snow Mode SW) |
|---|---|
| SNOW mode switch pushed and held | ON |
| SNOW mode switch not pushed | OFF |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>SFI SYSTEM>CHECK FOR INTERMITTENT PROBLEMS
NG
Click hereDrivetrain>UA80F (AUTOMATIC TRANSMISSION / TRANSAXLE)>PATTERN SELECT SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the pattern select switch assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| P5-5 (2ND) - C54-105 (SNWI) | Always | Below 1 Ω |
| P5-5 (2ND) or C54-105 (SNWI) - Body ground and other terminals | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the pattern select switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| P5-2 (E) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG