The characteristics of the electronic throttle and EPS operation change according to operation of the drive mode select switch (No.1 pattern select switch assembly).
| Result | Proceed to |
|---|---|
| CAN communication system DTCs are not output. | A |
| CAN communication system DTCs are output. | B |
A
B
Turn the ignition switch off.
| *a | Front view of wire harness connector
(to Drive Mode Select Switch (No. 1 Pattern Select Switch Assembly)) |
Disconnect the P3 drive mode select switch (No. 1 pattern select switch assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| P3-5 (E) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect drive mode select switch (No. 1 pattern select switch assembly).
Click hereDrivetrain>UA80F (AUTOMATIC TRANSMISSION / TRANSAXLE)>PATTERN SELECT SWITCH>INSPECTION
Drive mode select switch (No. 1 pattern select switch assembly) is normal.
| Result | Proceed to |
|---|---|
| Drive mode select switch (No. 1 pattern select switch assembly) is normal. | A |
| Drive mode select switch (No. 1 pattern select switch assembly) is abnormal. | B |
A
B
Connect the P3 drive mode select switch (No. 1 pattern select switch assembly) connector.
| *a | Front view of wire harness connector
(to ECM) |
Disconnect the A28 ECM connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A28-55 (PWMS) - Body ground | SPORT mode switch being turned and held | Below 1 Ω |
| A28-55 (PWMS) - Body ground | SPORT mode switch not turned | 10 kΩ or higher |
| A28-40 (SPCN) - Body ground | NORMAL mode switch being pushed and held | Below 1 Ω |
| A28-40 (SPCN) - Body ground | NORMAL mode switch not pushed | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG