Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › BATTERY VOLTAGE SENSOR
RM37A0E _51 Engine / Hybrid System _086850 HYBRID / BATTERY CONTROL _0419998 BATTERY VOLTAGE SENSOR A

HYBRID / BATTERY CONTROL  BATTERY VOLTAGE SENSOR  INSTALLATION  


PROCEDURE

Hide 89892A 1.INSTALL BATTERY VOLTAGE SENSOR

CAUTION:

Be sure to wear insulated gloves.


a.

Install the battery voltage sensor to the HV battery with the 2 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:
·

If the battery voltage sensor has been struck or dropped, replace it.

·

The type of battery voltage sensor to be used varies depending on the vehicle model.

·

If the wrong type of battery voltage sensor is installed, the ignition switch cannot be turned on (READY).

·

When replacing the battery voltage sensor, always replace it with a new one.




b.

Connect the 3 battery voltage sensor connectors.

NOTICE:

Make sure that the connector is connected securely.



Hide 2.INSTALL NO. 6 HV BATTERY CARRIER BRACKET

CAUTION:

Be sure to wear insulated gloves.


a.

Install the No. 6 HV battery carrier bracket with the 4 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


b.

Engage the clamp.


Hide G920Q 3.INSTALL NO. 1 HYBRID BATTERY SHIELD SUB-ASSEMBLY

Hide 82161 4.CONNECT FLOOR WIRE

CAUTION:

Be sure to wear insulated gloves.


a.

Engage the 3 clamps to connect the floor wire.


b.

Connect the electric vehicle battery plug assembly connector.


Hide 5.INSTALL HV BATTERY JUNCTION BLOCK ASSEMBLY