G92Z2
1.INSTALL HYBRID BATTERY TERMINAL BLOCK
Be sure to wear insulated gloves.
| *a | Pin |
Install the hybrid battery terminal block to the HV battery with the nut.
Make sure to align the hole of the hybrid battery terminal block with the pin.
Connect the 2 hybrid battery terminal block connectors.
Make sure that the connectors are connected securely.
G920Q
2.INSTALL NO. 1 HYBRID BATTERY SHIELD SUB-ASSEMBLY
Be sure to wear insulated gloves.
Install the No. 1 hybrid battery shield sub-assembly with the 6 nuts.
Install the electric vehicle battery plug assembly with the bolt.
82161
3.CONNECT FLOOR WIRE
Be sure to wear insulated gloves.
Engage the 3 clamps.
Connect the electric vehicle battery plug assembly connector.
Connect the HV battery junction block assembly connector.
Make sure that the connectors are connected securely.
Engage the clamp.
821H1
4.CONNECT FLOOR UNDER WIRE
G92QC
5.INSTALL NO. 10 HV BATTERY SHIELD PANEL
58556C
6.INSTALL REAR FLOOR SILENCER
58510D
7.INSTALL FRONT FLOOR CARPET ASSEMBLY
8.INSTALL REAR NO. 1 SEAT ASSEMBLY LH
9.INSTALL REAR NO. 1 SEAT ASSEMBLY RH
G3834
10.INSTALL SERVICE PLUG GRIP
11.PERFORM INITIALIZATION