Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HV RELAY ASSEMBLY
RM37A0E _51 Engine / Hybrid System _086850 HYBRID / BATTERY CONTROL _0420006 HV RELAY ASSEMBLY A

HYBRID / BATTERY CONTROL  HV RELAY ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 1.INSTALL HV BATTERY JUNCTION BLOCK ASSEMBLY

CAUTION:

Be sure to wear insulated gloves.


a.

Install the HV battery junction block assembly to the HV battery with the 4 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:

If the HV battery junction block assembly has been struck or dropped, replace it with a new one.



b.

Connect the HV battery junction block assembly connector.

NOTICE:

Make sure that the connector is connected securely.



c.

Connect the HV battery junction block assembly connector.

NOTICE:

Make sure that the connector is connected securely.



d.

Connect the HV battery junction block assembly connector.

NOTICE:

Make sure that the connector is connected securely.



Hide 82161 2.CONNECT FLOOR WIRE

CAUTION:

Be sure to wear insulated gloves.


a.

Connect the HV battery junction block assembly connector.

NOTICE:

Make sure that the connectors are connected securely.



b.

Engage the clamp.


Hide G92QC 4.INSTALL NO. 10 HV BATTERY SHIELD PANEL

Hide 58510D 6.INSTALL FRONT FLOOR CARPET ASSEMBLY