When the sliding roof ECU (sliding roof drive gear assembly) or roof sunshade ECU (sliding roof drive gear assembly) detects a motor malfunction and the sliding roof and roof sunshade operation is stopped, DTC B2341 is stored.
When the sliding roof ECU (sliding roof drive gear assembly) or roof sunshade ECU (sliding roof drive gear assembly) detects a gear position malfunction and the sliding roof and roof sunshade operation is stopped, DTC B2344 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2341 | Sensor (Motor) Failure | Sensor (motor) failure (When the sliding roof ECU (sliding roof drive gear assembly) enters fail-safe mode due to a problem with the motor) | ·
Sliding roof ECU (Sliding roof drive gear assembly) ·
Map light assembly ·
Wire harness or connector |
| B2344 | Position Failure | Position failure (When the sliding roof ECU (sliding roof drive gear assembly) enters fail-safe mode due to a problem with the gear position) | ·
Sliding roof ECU (Sliding roof drive gear assembly) ·
Map light assembly ·
Wire harness or connector |
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2341 | Sensor (Motor) Failure | Sensor (motor) failure (When the roof sunshade ECU (sliding roof drive gear assembly) enters fail-safe mode due to a problem with the motor) | ·
Roof sunshade ECU (Sliding roof drive gear assembly) ·
Map light assembly ·
Wire harness or connector |
| B2344 | Position Failure | Position failure (When the roof sunshade ECU (sliding roof drive gear assembly) enters fail-safe mode due to a problem with the gear position) | ·
Roof sunshade ECU (Sliding roof drive gear assembly) ·
Map light assembly ·
Wire harness or connector |
If the sliding roof ECU (sliding roof drive gear assembly) or roof sunshade ECU (sliding roof drive gear assembly) is removed and reinstalled or replaced, the sliding roof ECU (sliding roof drive gear assembly) or roof sunshade ECU (sliding roof drive gear assembly) must be initialized.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>PANORAMIC MOON ROOF SYSTEM>INITIALIZATION
The panoramic moon roof system uses the LIN communication system. First, confirm that there are no malfunctions in the LIN communication system. Refer to How to Proceed with Troubleshooting.
DTCs B2341 and B2344 are stored in the sliding roof ECU (sliding roof drive gear assembly) and roof sunshade ECU (sliding roof drive gear assembly).
Clear the DTCs.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>PANORAMIC MOON ROOF SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>PANORAMIC MOON ROOF SYSTEM>DTC CHECK / CLEAR
DTCs B2341 and B2344 are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Check the parts from which this DTC has been output.
| Result | Proceed to |
|---|---|
| DTC output from sliding roof ECU (sliding roof drive gear assembly) | A |
| DTC output from roof sunshade ECU (sliding roof drive gear assembly) | B |
A
B
Check the sliding roof auto operation function.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>PANORAMIC MOON ROOF SYSTEM>OPERATION CHECK
Auto operation function operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>PANORAMIC MOON ROOF SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
DTCs B2341 and B2344 are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF HOUSING (for Panoramic Moon Roof)>REMOVAL
Check that the sliding roof ECU (sliding roof drive gear assembly) can be initialized.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>PANORAMIC MOON ROOF SYSTEM>INITIALIZATION
Sliding roof ECU (sliding roof drive gear assembly) can be initialized.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>PANORAMIC MOON ROOF SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
DTCs B2341 and B2344 are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF HOUSING (for Panoramic Moon Roof)>REMOVAL
Disconnect the R19 sliding roof ECU (sliding roof drive gear assembly) connector.
Disconnect the R11 map light assembly connector.
Disconnect the R20 roof sunshade ECU (sliding roof drive gear assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| R19-5 (CLS) - R11-19 (CLS) | Always | Below 1 Ω |
| R19-5 (CLS) or R11-19 (CLS) - Body ground | Always | 10 kΩ or higher |
| R19-7 (OPN) - R11-20 (OPN) | Always | Below 1 Ω |
| R19-7 (OPN) or R11-20 (OPN) - Body ground | Always | 10 kΩ or higher |
| R19-2 (TILT) - R11-16 (VENT) | Always | Below 1 Ω |
| R19-2 (TILT) or R11-16 (VENT) - Body ground | Always | 10 kΩ or higher |
| R19-6 (OPN) - R11-17 (OPN) | Always | Below 1 Ω |
| R19-6 (OPN) or R11-17 (OPN) - Body ground | Always | 10 kΩ or higher |
| R19-4 (CLS) - R11-18 (CLS) | Always | Below 1 Ω |
| R19-4 (CLS) or R11-18 (CLS) - Body ground | Always | 10 kΩ or higher |
| R19-12 (E) - Body ground | Always | Below 1 Ω |
| R11-11 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SWITCH ASSEMBLY>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF HOUSING (for Panoramic Moon Roof)>REMOVAL
NG
Check the roof sunshade auto operation function.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>PANORAMIC MOON ROOF SYSTEM>OPERATION CHECK
Auto operation function operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>PANORAMIC MOON ROOF SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
DTCs B2341 and B2344 are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF HOUSING (for Panoramic Moon Roof)>REMOVAL
Check that the roof sunshade ECU (sliding roof drive gear assembly) can be initialized.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>PANORAMIC MOON ROOF SYSTEM>INITIALIZATION
Roof sunshade ECU (sliding roof drive gear assembly) can be initialized.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>PANORAMIC MOON ROOF SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
DTCs B2341 and B2344 are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF HOUSING (for Panoramic Moon Roof)>REMOVAL
Disconnect the R20 roof sunshade ECU (sliding roof drive gear assembly) connector.
Disconnect the R11 map light assembly connector.
Disconnect the R19 sliding roof ECU (sliding roof drive gear assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| R20-5 (CLS) - R11-19 (CLS) | Always | Below 1 Ω |
| R20-5 (CLS) or R11-19 (CLS) - Body ground | Always | 10 kΩ or higher |
| R20-7 (OPN) - R11-20 (OPN) | Always | Below 1 Ω |
| R20-7 (OPN) or R11-20 (OPN) - Body ground | Always | 10 kΩ or higher |
| R20-2 (TILT) - R11-16 (VENT) | Always | Below 1 Ω |
| R20-2 (TILT) or R11-16 (VENT) - Body ground | Always | 10 kΩ or higher |
| R20-6 (OPN) - R11-17 (OPN) | Always | Below 1 Ω |
| R20-6 (OPN) or R11-17 (OPN) - Body ground | Always | 10 kΩ or higher |
| R20-4 (CLS) - R11-18 (CLS) | Always | Below 1 Ω |
| R20-4 (CLS) or R11-18 (CLS) - Body ground | Always | 10 kΩ or higher |
| R20-12 (E) - Body ground | Always | Below 1 Ω |
| R11-11 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SWITCH ASSEMBLY>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF HOUSING (for Panoramic Moon Roof)>REMOVAL
NG