The hybrid vehicle control ECU monitors the voltage of the HV battery. The hybrid vehicle control ECU stops compressor control and stores this DTC when the monitored voltage is outside the specified range.
This DTC will be stored as a history DTC. Compressor control may not resume unless the ignition switch is turned off.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory |
|---|---|---|---|---|
| B1471 | A/C Inverter High Voltage Power Resource System | Open or short in A/C inverter high voltage power resource system | ·
CAN communication system ·
Hybrid control system ·
HV air conditioning wire ·
Compressor with motor assembly |
Memorized |
Before inspecting the high-voltage system, take safety precautions such as wearing insulated gloves and removing the service plug grip to prevent electrical shocks. After removing the service plug grip, put it in your pocket to prevent other technicians from accidentally reconnecting it while you are working on the high-voltage system.
Do not touch the high-voltage connectors or terminals for 10 minutes after the service plug grip is removed.
Inspect the fuses for circuits related to this system before performing the following procedure.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
The hybrid control system and air conditioning system output DTCs separately. Perform troubleshooting for the hybrid control system first if DTCs for both systems are output simultaneously.
The air conditioning system uses the CAN communication system. Inspect the communication functions by following How to Proceed with Troubleshooting. Troubleshoot the air conditioning system after confirming that the communication systems are functioning properly.
Using the GTS, check if the CAN communication system is functioning normally.
| Result | Proceed to |
|---|---|
| CAN communication system DTCs are not output | A |
| CAN communication system DTCs are output | B |
A
B
Check for DTCs.
Hybrid control system DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for 2WD: Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for 2WD)>HOW TO PROCEED WITH TROUBLESHOOTING
for AWD: Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for 4WD/AWD)>HOW TO PROCEED WITH TROUBLESHOOTING
Be sure to wear insulated gloves.
Remove the HV air conditioning wire.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>INVERTER WITH CONVERTER>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| m1-2 (PB) - m2-1 (ACPB) | Always | Below 1 Ω |
| m1-1 (PE) - m2-2 (ACPE) | Always | Below 1 Ω |
| m1-2 (PB) - Other terminals and body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG