Home › Drivetrain › P810 (HYBRID TRANSMISSION / TRANSAXLE) › OIL PUMP
RM37A0E _52 Drivetrain _086860 P810 HYBRID TRANSMISSION / TRANSAXLE _0420890 OIL PUMP A

P810 HYBRID TRANSMISSION / TRANSAXLE  OIL PUMP  INSTALLATION  


PROCEDURE

Hide 35300B 1.INSTALL OIL PUMP WITH MOTOR ASSEMBLY

a.

Install the oil pump with motor assembly to the engine assembly with the 2 bolts.

Torque:
46 N*m (469 kgf*cm, 34 ft.*lbf)


b.

Connect the oil pump with motor assembly connector.


c.

Install the wire harness clamp bracket to the oil pump with motor assembly with the bolt.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


Hide 32930G 2.CONNECT NO. 2 TRANSMISSION OIL COOLER HOSE ASSEMBLY

a.
C426787C01
0.646,0.396 0.802,0.396 0.802,0.396 0.99,0.771 true 1.646,0.469 1.51,0.469 1.51,0.469 1.292,0.781 true 0.896,1.135 1.146,1.333 0.25,0.198 10 false *a 0.917,0.24 1.167,0.448 0.25,0.208 10 false *b 1.698,0.365 2,0.552 0.302,0.188 10 false *c 0.458,0.313 0.771,0.469 0.313,0.156 10 false *d 0.521,0.719 0.708,0.917 0.188,0.198 10 false *e 1.958,0.521 2.188,0.74 0.229,0.219 10 false *f 1.958,0.948 2.188,1.167 0.229,0.219 10 false *f
*a 0 to 3 mm (0 to 0.118 in.)
*b 2 to 7 mm (0.0787 to 0.276 in.)
*c Paint Mark
*d Marking
*e Center of Paint Mark
*f 45° (Claw of Clip Location)


Connect the No. 2 transmission oil cooler hose assembly to the oil pump with motor assembly and slide the 2 clips to secure it.

NOTICE:
·

Make sure to slide the No. 2 transmission oil cooler hose assembly until it contacts the hose stopper of the oil pump with motor assembly.

·

Make sure to align the paint mark on each No. 2 transmission oil cooler hose assembly with each marking on the oil pump with motor assembly.

·

Make sure that the claws of the clip are within the location shown in the illustration.




Hide 5.INSPECT FOR HYBRID TRANSAXLE FLUID LEAK

Hide 51420 6.INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY

Hide 53851D 8.INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

Hide 53852B 9.INSTALL FRONT WHEEL OPENING EXTENSION PAD LH