32913G
1.INSTALL TRANSMISSION OIL COOLER BRACKET
Perform this procedure only when replacement of the transmission oil cooler bracket, No. 2 transmission oil cooler bracket or No. 3 transmission oil cooler bracket is necessary.
Install the No. 3 transmission oil cooler bracket to the No. 2 transmission oil cooler bracket with the nut.
|
Nut |
|
Bolt |
Engage the guide and install the transmission oil cooler bracket to the vehicle body with the 2 nuts and bolt.
Tightening order: Temporarily tighten bolt → Fully tighten nut (A) → Fully tighten nut (B) → Fully tighten bolt
32910L
2.INSTALL OIL COOLER ASSEMBLY
Install the oil cooler assembly to the transmission oil cooler bracket with the 2 nuts and bolt.
32930F
3.CONNECT NO. 1 TRANSMISSION OIL COOLER HOSE ASSEMBLY
| *a | 0 to 3 mm (0 to 0.118 in.) |
| *b | 2 to 7 mm (0.0787 to 0.276 in.) |
| *c | Paint Mark |
| *d | Inlet Oil Hose |
| *e | Outlet Oil Hose |
| *f | Front of Vehicle |
Connect the No. 1 transmission oil cooler hose assembly to the oil cooler assembly and slide the 2 clips to secure it.
Make sure to slide the No. 1 transmission oil cooler hose assembly until it contacts the hose stopper of the oil cooler assembly.
Make sure to align the paint mark of the No. 1 transmission oil cooler hose assembly (inlet oil hose) with the paint mark of the oil cooler assembly (inlet oil pipe).
32917A
4.INSTALL TRANSMISSION OIL COOLER AIR DUCT
Engage the guide to temporarily install the transmission oil cooler air duct to the oil cooler assembly.
Install the transmission oil cooler air duct to the oil cooler assembly with the 3 bolts.
Tightening order: Bolt (A) → Bolt (B) → Bolt (C)
5.INSPECT HYBRID TRANSAXLE FLUID
6.INSPECT FOR HYBRID TRANSAXLE FLUID LEAK
51420
7.INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
51441
8.INSTALL NO. 1 ENGINE UNDER COVER
53851D
9.INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
53852B
10.INSTALL FRONT WHEEL OPENING EXTENSION PAD LH