| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C052C1C | ABS Pump Motor Control Circuit Voltage Out of Range | When the +BS terminal voltage is from 9.5 to 17.4 V with the motor relay and motor fail safe relay OFF, an open or short in motor circuit continues for 2 seconds or more. | ·
Skid control ECU (brake actuator assembly) ·
Wire harness and connector |
Refer to DTC C052C13.
After replacing the skid control ECU (brake actuator assembly), perform "Calibration".
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
The connector is securely connected.
Disconnect the A39 skid control ECU (brake actuator assembly) connector.
Check both the connector case and the terminals for deformation and corrosion.
No deformation or corrosion.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A39-30 (GND2) - Body ground | 1 minute or more after disconnecting the cable from the negative (-) auxiliary battery terminal | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for Gasoline Model LHD)>REMOVAL
NG