Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model) › 2020.02–2020.11
RM37A0E _54 Brake _086868 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0420942 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model)  C124A00  ECM Communication  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
C124A00 ECM Communication Any of the following is detected:
·

The engine type, powertrain variation, engine stop and start ECU availability and destination information sent from the ECM do not match the information stored in the skid control ECU (brake actuator assembly).

·

No system information stored in the skid control ECU (brake actuator assembly).

·

When the skid control ECU (brake actuator assembly) is malfunctioning.


·

Incorrect ECM installed

·

Skid control ECU (Brake actuator assembly)



CAUTION / NOTICE / HINT

NOTICE:

After replacing the skid control ECU (brake actuator assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model)>UTILITY


PROCEDURE

1.CHECK PART NUMBER (ECM)
a.

Check that the proper ECM is installed.

OK:

Proper ECM is installed.



Result:
Proceed to
OK
NG



OK

2.CHECK PART NUMBER (BRAKE ACTUATOR ASSEMBLY)

NG

2.CHECK PART NUMBER (BRAKE ACTUATOR ASSEMBLY)
a.

Check that the proper skid control ECU (brake actuator assembly) is installed.

OK:

Proper skid control ECU (brake actuator assembly) is installed.



Result:
Proceed to
OK
NG



OK

3.SYSTEM INFORMATION MEMORIZATION

NG

3.SYSTEM INFORMATION MEMORIZATION
a.

Perform system information memorization.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model)>UTILITY

Chassis > Brake/EPB > Utility
Tester Display
Reset Memory
50005 435 4560
Chassis > Brake/EPB > Utility
Tester Display
Calibration
50005 435 4554
HINT:
·

If a new skid control ECU (brake actuator assembly) was installed, C121054 and C051D54 are output before "Calibration" is performed.

·

After performing "Reset Memory" using the GTS to clear the memorized value of the skid control ECU (brake actuator assembly), DTCs C121054 and C051D54 will be stored until system information memorization is performed.




Result:
Proceed to
NEXT



NEXT

4.CLEAR DTC
4.CLEAR DTC
a.

Clear the DTCs.

Chassis > Brake/EPB > Clear DTCs
50002 435

b.

Turn the ignition switch off.


Result:
Proceed to
NEXT



NEXT

5.RECONFIRM DTC
5.RECONFIRM DTC
a.

Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.


b.

Check if the same DTC is output.

Chassis > Brake/EPB > Trouble Codes
50001 435

Result:
Result Proceed to
DTC C124A00 is not output. A
DTC C124A00 is output. B



A

END

B