Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › REAR MOTOR GENERATOR CONTROL SYSTEM
RM37A0E _51 Engine / Hybrid System _086850 HYBRID / BATTERY CONTROL _0420997 REAR MOTOR GENERATOR CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  REAR MOTOR GENERATOR CONTROL SYSTEM  P1BF946  Internal Control Module (EEPROM Estimated Temperature Information) Calibration / Parameter Memory Failure  


DESCRIPTION

The inverter with converter assembly monitors its internal operation and will store this DTC if it detects a malfunction of its EEPROM.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate
P1BF946 Internal Control Module (EEPROM Estimated Temperature Information) Calibration / Parameter Memory Failure ECU internal malfunction
(EEPROM error)
(2 trip detection logic)
Inverter with converter assembly Does not come on Master Warning:
Comes on

CONFIRMATION DRIVING PATTERN

HINT:

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>REAR MOTOR GENERATOR CONTROL SYSTEM>UTILITY


1.

Connect the GTS to the DLC3.

2.

Turn the ignition switch to ON and turn the GTS on.

3.

Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

4.

Turn the ignition switch off and wait for 2 minutes or more.

5.

Turn the ignition switch ON and wait for 5 seconds or more.

6.

Turn the ignition switch off and wait for 2 minutes or more.

7.

Turn the ignition switch to ON and turn the GTS on.

8.

With ignition switch ON and wait for 5 seconds or more.

9.

Enter the following menus: Powertrain / Rear Motor Generator / Utility / All Readiness.

10.

Check the DTC judgment result.

HINT:
·

If the judgment result shows NORMAL, the system is normal.

·

If the judgment result shows ABNORMAL, the system has a malfunction.

·

If the judgment result shows INCOMPLETE, perform driving pattern again.




PROCEDURE

1.CHECK AUXILIARY BATTERY VOLTAGE

Click herePower Source / Network>A25A-FXS, A25B-FXS (BATTERY / CHARGING)>CHARGING SYSTEM>ON-VEHICLE INSPECTION

HINT:

If the auxiliary battery voltage inspection results are normal, perform the next step.


Result:
Proceed to
NEXT



NEXT

2.CLEAR DTC
2.CLEAR DTC
a.

Clear the DTCs.

Powertrain > Rear Motor Generator > Clear DTCs
50002 396

b.

Turn the ignition switch off and wait for 2 minutes or more.


Result:
Proceed to
NEXT



NEXT

3.SIMULATION TEST
3.SIMULATION TEST
a.

Turn the ignition switch to ON and wait for 5 seconds or more.


b.

Turn the ignition switch off and wait for 2 minutes or more.


c.

Turn the ignition switch to ON and wait for 5 seconds or more.


d.

Check for DTCs.

Powertrain > Rear Motor Generator > Trouble Codes
50001 396
Result:
Result Proceed to
P1BF946 is output. A
P1BF946 is not output. B



e.

Turn the ignition switch off.



A

REPLACE INVERTER WITH CONVERTER ASSEMBLY

B