When the ignition switch is turned ON (READY), the stop light switch assembly off and the vehicle speed is 20 km/h (12 mph) or more, the No. 2 skid control ECU (brake actuator assembly) performs a self-diagnosis of the ABS motor relay circuit during the initial check of the actuator.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| C142771 | ABS Pump Motor Actuator Stuck | When the actuator initial check is being performed, the actuator pump motor does not operate properly. | ·
Wire harness and connector ·
Brake actuator assembly (pump motor) ·
Brake actuator assembly (pump motor circuit) |
Output ECU: No. 2 skid control ECU (brake actuator assembly) |
Refer to DTCs C052C14, C052C16, C052C17, C052C29, C052C49 and C052F14.
Inspect the fuses for circuits related to this system before performing the following procedure.
After replacing the No. 2 skid control ECU (brake actuator assembly), perform "Calibration".
Check the operating sound of the pump motor when operating it using the GTS.
| Tester Display | Measurement Item | Control Range | Restrict Condition | Diagnostic Note |
|---|---|---|---|---|
| Motor Relay | ABS motor relay | OFF / ON | Vehicle condition: Vehicle stopped
|
Operating sound of motor can be heard |
| Tester Display |
|---|
| Motor Relay |
| Result | Proceed to |
|---|---|
| Operating sound is heard. | A |
| Operating sound is not heard. | B |
A
B
Clear the DTCs.
Turn the ignition switch off.
| Proceed to |
|---|
| NEXT |
NEXT
Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.
Check if the same DTC is output.
| Result | Proceed to |
|---|---|
| DTC C142771 is not output. | A |
| DTC C142771 is output. | B |
If a speed signal of 20 km/h (12 mph) or more is input to the No. 2 skid control ECU (brake actuator assembly) with the ignition switch turned to ON and the stop light switch assembly off, the ECU performs self-diagnosis of the pump motor circuit.
If the normal system code is output (no DTCs are output), slightly jiggle the connectors, wire harness, and fuses of the No. 2 skid control ECU (brake actuator assembly).
If any DTCs are output while jiggling a connector or wire harness of the No. 2 skid control ECU (brake actuator assembly), inspect and repair the connector or wire harness.
If no DTCs were output when reconfirming DTCs, checking for intermittent problems is necessary because it is suspected that the original DTCs were stored due to the poor connection of a connector terminal.
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Turn the ignition switch off.
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
The connector is securely connected.
Disconnect the A57 No. 2 skid control ECU (brake actuator assembly) connector.
Check both the connector case and the terminals for deformation and corrosion.
No deformation or corrosion.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A57-30 (GND2) - Body ground | 1 minute or more after disconnecting the cable from the negative (-) auxiliary battery terminal | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG