Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)
RM37A0E _54 Brake _086868 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0421002 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model)  C052062  Multi-axis Acceleration Sensor Module "A" Signal Compare Failure  


DESCRIPTION

The yaw rate sensor has a built-in acceleration sensor.

The No. 2 skid control ECU (brake actuator assembly) receives signals from the acceleration sensor (yaw rate sensor) via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
C052062 Multi-axis Acceleration Sensor Module "A" Signal Compare Failure After the difference between GL1 and GL2 becomes 0.6 G or more with the vehicle stationary, the difference remains 0.4 G or more for 60 seconds or more.
·

Acceleration sensor (yaw rate sensor) installation

·

Acceleration sensor (yaw rate sensor)


Output ECU: No. 2 skid control ECU (brake actuator assembly)

CAUTION / NOTICE / HINT

NOTICE:

After replacing or reinstalling the yaw rate sensor, perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>UTILITY


PROCEDURE

1.CHECK YAW RATE SENSOR INSTALLATION
a.

Check that the acceleration sensor (yaw rate sensor) has been installed properly.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>YAW RATE AND ACCELERATION SENSOR>INSTALLATION

OK:

The acceleration sensor (yaw rate sensor) is tightened to the specified torque.

The acceleration sensor (yaw rate sensor) is not installed in a tilted position.



Result:
Proceed to
OK
NG



OK

NG