The yaw rate sensor has a built-in acceleration sensor.
If the identification ID of the yaw rate sensor is different to that stored in the No. 2 skid control ECU (brake actuator assembly), this DTC is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| C124000 | Yaw Rate Sensor / Multi-axis Acceleration Sensor Module "A" | The yaw rate sensor identification information stored in the No. 2 skid control ECU (brake actuator assembly) is not consistent with the yaw rate sensor identification information sent via CAN communication continuously for 1 second or more. | ·
Incorrect yaw rate sensor installed ·
No. 2 skid control ECU (brake actuator assembly) |
Output ECU: No. 2 skid control ECU (brake actuator assembly) |
After replacing or reinstalling the yaw rate sensor, perform "Calibration".
After replacing the No. 2 skid control ECU (brake actuator assembly), perform "Calibration".
Check that the part number of the installed yaw rate sensor is correct.
Yaw rate sensor installed in the vehicle has the correct part number.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Turn the ignition switch off.
| Proceed to |
|---|
| NEXT |
NEXT
Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.
Check if the same DTC is output.
| Result | Proceed to |
|---|---|
| DTC C124000 is not output. | A |
| DTC C124000 is output. | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B