Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)
RM37A0E _54 Brake _086868 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0421002 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model)  C124F62  Yaw Rate Sensor Signal Compare Failure  


DESCRIPTION

The yaw rate sensor has a built-in acceleration sensor.

This DTC is stored when the No. 2 skid control ECU (brake actuator assembly) detects improper installation of the yaw rate sensor or an abnormality in the difference between the yaw rate sensor value and the control value estimated based on the acceleration sensor (yaw rate sensor), steering angle sensor and speed sensor signals.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
C124F62 Yaw Rate Sensor Signal Compare Failure A yaw rate sensor comparison malfunction status continues.
·

Yaw rate sensor installation

·

Yaw rate sensor


Output ECU: No. 2 skid control ECU (brake actuator assembly)

CAUTION / NOTICE / HINT

NOTICE:

After replacing or reinstalling the yaw rate sensor, perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>UTILITY


PROCEDURE

1.READ VALUE USING GTS (YAW RATE SENSOR)
a.

Perform a road test.


b.

Check the yaw rate sensor output value displayed on the GTS.

Chassis > Brake/EPB > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Yaw Rate Sensor Value Yaw rate sensor Min.: -128°/s
Max.: 127°/s
Vehicle stopped: 0°/s
Turning right: -128 to 0°/s
Turning left: 0 to 127°/s
-
Chassis > Brake/EPB > Data List
Tester Display
Yaw Rate Sensor Value
50003 435 29

Result:
Result Proceed to
NG (The yaw rate sensor output value is 0°/s when the vehicle is stationary, but the value fluctuates when turning.) A
NG (The yaw rate sensor output value is not 0°/s when the vehicle is stationary.) B
OK C



A

2.CHECK YAW RATE SENSOR INSTALLATION

B

C

2.CHECK YAW RATE SENSOR INSTALLATION
a.

Turn the ignition switch off.


b.

Check that the yaw rate sensor has been installed properly.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>YAW RATE AND ACCELERATION SENSOR>INSTALLATION

OK:

The yaw rate sensor is tightened to the specified torque.

The yaw rate sensor is not installed in a tilted position.



Result:
Proceed to
OK
NG



OK

NG