| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| C124A00 | ECM Communication | Either of the following is detected:
·
The engine type, powertrain variation and destination information sent from the hybrid vehicle control ECU do not match the information stored in the No. 2 skid control ECU (brake actuator assembly). ·
No system information stored in the No. 2 skid control ECU (brake actuator assembly). |
·
Incorrect hybrid vehicle control ECU installed ·
No. 2 skid control ECU (brake actuator assembly) |
Output ECU: No. 2 skid control ECU (brake actuator assembly) |
After replacing the No. 2 skid control ECU (brake actuator assembly), perform "Calibration".
Before replacing the hybrid vehicle control ECU, refer to Service Bulletin.
Check that the proper hybrid vehicle control ECU is installed.
Proper hybrid vehicle control ECU is installed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check that the proper No. 2 skid control ECU (brake actuator assembly) is installed.
Proper No. 2 skid control ECU (brake actuator assembly) is installed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Perform system information memorization.
| Tester Display |
|---|
| Reset Memory |
| Tester Display |
|---|
| Calibration |
After performing "Reset Memory" using the GTS to clear the memorized value of the No. 2 skid control ECU (brake actuator assembly), DTC C124A00 will be stored until system information memorization is performed.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Turn the ignition switch off.
| Proceed to |
|---|
| NEXT |
NEXT
Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.
Check if the same DTC is output.
| Result | Proceed to |
|---|---|
| DTC C124A00 is not output. | A |
| DTC C124A00 is output. | B |
A
B