Refer to DTC C110E14.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| C14C616 | Electronic Brake Booster Control Module "A" Supply Voltage Circuit Voltage Below Threshold | Either of the following is detected:
·
Any of the following is detected when the ECU internal voltage is 6.92 V or less: -
When operation of the main relay is requested, the relay output voltage is less than a certain value for 10.05 seconds or more. -
The stroke sensor value invalid for 10.2 seconds or more. -
The reaction force pressure sensor value invalid for 10.2 seconds or more. -
The voltage supplied to the servo pressure sensor is a certain value or less or a certain value or more for 10.06 seconds or more. -
The servo pressure sensor value invalid for 10.2 seconds or more. -
The voltage supplied to the reaction force pressure sensor is a certain value or less or a certain value or more for 10.06 seconds or more. ·
When the internal voltage of the ECU is 8.3 V or less, the accumulator pressure sensor value is invalid for 10.8 seconds or more. |
·
Improperly connected connector, deformation or corrosion of terminals ·
Wire harness and connector ·
No. 1 skid control ECU (brake booster with master cylinder assembly) |
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) |
Refer to DTC C110E14.
Inspect the fuses for circuits related to this system before performing the following procedure.
Before performing troubleshooting, make sure to confirm that the auxiliary battery voltage is normal.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
After replacing the No. 1 skid control ECU (brake booster with master cylinder assembly), perform "Calibration".
Check the DTCs that are output.
| Result | Proceed to |
|---|---|
| Only DTC C14C616 is output. | A |
| DTCs other than C14C616 are output. | B |
A
B
| *a | Front view of wire harness connector
(to No. 1 Skid Control ECU (Brake Booster with Master Cylinder Assembly)) |
Turn the ignition switch off.
Make sure that there is no looseness at the locking part and the connecting part of the connector.
The connector is securely connected.
Disconnect the A44 No. 1 skid control ECU (brake booster with master cylinder assembly) connector.
Check both the connector case and the terminals for deformation and corrosion.
No deformation or corrosion.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A44-31 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
| A44-14 (+BI1) - Body ground | Ignition switch ON | 11 to 14 V |
| A44-15 (BS) - Body ground | Ignition switch ON | 11 to 14 V |
| Result | Proceed to |
|---|---|
| 11 to 14 V. | A |
| Below 11 V. | B |
A
B