Home › Drivetrain › AXLE AND DIFFERENTIAL › DIFFERENTIAL MOUNT CUSHION
RM37A0E _52 Drivetrain _086863 AXLE AND DIFFERENTIAL _0421151 DIFFERENTIAL MOUNT CUSHION A

AXLE AND DIFFERENTIAL  DIFFERENTIAL MOUNT CUSHION  INSTALLATION  


PROCEDURE

Hide 41651 1.INSTALL REAR NO. 1 DIFFERENTIAL MOUNT CUSHION

a.

Using SST, install a new rear No. 1 differential mount cushion.

SST
09570-48010  

C426377C01
1.01,2.396 1.01,2.479 1.01,2.479 1.271,2.479 false 6.052,2.438 6.052,2.188 6.052,2.188 6.615,2.188 false 6.365,2.479 6.365,2.188 false 6.292,1.073 6.292,1.563 6.292,1.563 6.573,1.563 true 1.323,2.396 1.781,2.594 0.458,0.198 10 false SST 6.656,2.104 6.969,2.313 0.313,0.208 10 false SST 6.479,3.375 6.646,3.583 0.167,0.208 10 false A 6.615,1.479 6.781,1.688 0.167,0.208 10 false *b 6.021,0.219 6.24,0.521 0.219,0.302 10 false *a
*a 0° +/- 3° *b Hole
V100135

Front of the Vehicle - -


Standard Distance (A):

15.3 to 16.3 mm (0.602 to 0.642 in.)


NOTICE:
·

Make sure that the rear No. 1 differential mount cushion is aligned within 3° from the center.

·

Install the rear No. 1 differential mount cushion so that the hole is positioned as shown in the illustration.

·

Temporarily install the rear No. 1 differential mount cushion to the rear suspension member sub-assembly in order to prevent it from tilting, and then install SST.

·

Before using SST, apply grease to the SST bolt.

·

Be sure to use the correct combination of SST.

·

Be sure to use the correct direction of SST.

·

Make sure that SST contacts the entire circumference of the rear No. 1 differential mount cushion.

·

Do not tilt the bolts of SST.

·

Tighten the 2 bolts of SST so that they enter the 2 holes of the rear No. 1 differential mount cushion by an equal amount.




Hide 2.INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY (for Dynamic Torque Control AWD)

Hide 3.INSTALL TORQUE VECTORING DIFFERENTIAL CARRIER ASSEMBLY (for Dynamic Torque Vectoring AWD)

Hide 4.INSTALL SPARE TIRE