41196
1.INSTALL REAR DIFFERENTIAL DYNAMIC DAMPER
Install the rear differential dynamic damper to the rear No. 2 differential support with a new bolt.
52380C
2.TEMPORARILY INSTALL REAR NO. 2 DIFFERENTIAL SUPPORT
Temporarily install the rear No. 2 differential support to the torque vectoring differential carrier assembly with the 2 bolts and 2 nuts.
Reuse the removed bolts and nuts.
Be sure to install the rear No. 2 differential support facing the direction shown in the illustration.
The nuts have tabs to prevent them from rotating.
Install the 2 rear upper differential mount stoppers to the rear No. 2 differential support.
52391B
3.INSTALL DIFFERENTIAL SUPPORT
Install the differential support to the torque vectoring differential carrier assembly with 3 new bolts.
Tighten the bolt (A) shown in the illustration first.
41196C
4.INSTALL REAR NO. 2 DIFFERENTIAL DYNAMIC DAMPER
Install the rear No. 2 differential dynamic damper and 2 rear upper differential mount stoppers to the differential support with 2 new bolts.
41110
5.INSTALL TORQUE VECTORING DIFFERENTIAL CARRIER ASSEMBLY
Do not damage the contact surface when installing the torque vectoring differential carrier assembly.
Securely support the torque vectoring differential carrier assembly while performing this step to avoid excessively tilting or dropping the torque vectoring differential carrier assembly.
Install the bolts and nuts with the torque vectoring differential carrier assembly secured.
Support the torque vectoring differential carrier assembly with a transmission jack using 2 attachments or equivalent tools as shown in the illustration.
Temporarily install the torque vectoring differential carrier assembly to the rear suspension member sub-assembly with the 2 rear lower differential mount stoppers, 2 new bolts (A), 2 new bolts (B) and 2 new nuts.
| *a | Attachment | - | - |
|
Attachment Installation Position | - | - |
Tighten the 2 bolts (A).
Do not tighten the bolts with the inner cylinder or rear No. 1 differential mount cushion tilted.
Tighten the 2 bolts (B).
Do not tighten the bolts with the inner cylinder or rear differential mount cushion tilted.
Engage the clamp to install the frame wire.
Connect the 2 connectors and breather tube.
52391A
6.INSTALL REAR DIFFERENTIAL SUPPORT
Remove the 2 bolts and 2 nuts.
Temporarily install the rear differential support to the torque vectoring differential carrier assembly with 2 new bolts (A) and 2 new nuts.
Be sure to install the tabs of each nut to the positions (C) shown in the illustration.
The nuts have tabs to prevent them from rotating.
Temporarily install 2 new bolts (B).
Tighten the 4 bolts.
48812
7.INSTALL REAR STABILIZER BAR
8.INSTALL REAR DRIVE SHAFT ASSEMBLY
Install the rear drive shaft assembly LH and RH.
Click hereDrivetrain>DRIVE SHAFT / PROPELLER SHAFT>REAR DRIVE SHAFT ASSEMBLY (for 2GR-FKS)>INSTALLATION
37100
9.INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
10.ADD DIFFERENTIAL OIL
11.INSPECT FOR DIFFERENTIAL OIL LEAK
12. DYNAMIC TORQUE VECTORING AWD SYSTEM CALIBRATION