Home › Drivetrain › GF2A (TRANSFER / 4WD / AWD) › DYNAMIC TORQUE VECTORING AWD SYSTEM
RM37A0E _52 Drivetrain _086861 GF2A TRANSFER / 4WD / AWD _0421156 DYNAMIC TORQUE VECTORING AWD SYSTEM C

GF2A TRANSFER / 4WD / AWD  DYNAMIC TORQUE VECTORING AWD SYSTEM  C13F800  4WD/AWD Rear Disconnect System Performance  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory
C13F800 4WD/AWD Rear Disconnect System Performance
·

It is determined that rotation synchronization is not possible when switching from disengaged to engaged for 7 seconds continuously a total of 9 times.

·

Any of the following conditions occur a total of 5 times consecutively:

-

After switching from disengaged to engaged, the No. 2 4 wheel drive position switch does not indicate engaged for 6 seconds continuously.

-

After switching from engaged to disengaged, the No. 2 4 wheel drive position switch does not indicate disengaged for 5 seconds continuously.

-

When there is no request to change state, the No. 2 4 wheel drive position switch changes to another state for 60 seconds continuously.



·

Rear 4WD linear solenoid (rear differential carrier assembly)

·

No. 2 4 wheel drive position switch


Displayed Yes

DTC Detection Conditions: C13F800
Vehicle Condition
Pattern 1 Pattern 2 Pattern 3 Pattern 4 Pattern 5
Diagnosis Condition When switching from disengaged to engaged ○ ○ - - -
When switching from engaged to disengaged - - ○ - -
Disengaged - - - ○ -
Engaged - - - - ○
Malfunction Status Rotation synchronization is not possible for 7 seconds continuously ○ - - - -
The No. 2 4 wheel drive position switch does not indicate engaged for 6 seconds continuously - ○ - - -
The No. 2 4 wheel drive position switch does not indicate disengaged for 5 seconds continuously - - ○ - -
The No. 2 4 wheel drive position switch changes to another state for 60 seconds continuously. - - - ○ ○
Detection Time 9 times for pattern 1 Any malfunction status occur a total of 5 times consecutively for patterns 2 to 5
Number of Trips -

HINT:

DTC will be stored when conditions for either of the patterns in the table above are met.


CAUTION / NOTICE / HINT

NOTICE:

After performing repairs, clear the DTCs and check that the DTCs are not output again.

Click hereDrivetrain>GF2A (TRANSFER / 4WD / AWD)>DYNAMIC TORQUE VECTORING AWD SYSTEM>DTC CHECK / CLEAR


PROCEDURE

1.CHECK FOR DTC
a.

Check whether DTCs other than C13F800 are output.

Chassis > Four Wheel Drive > Trouble Codes
50001 448

Result:
Result Proceed to
Only DTC C13F800 is output. A
DTC C13F800 and C13E01C are output. B
DTC C13F800 and C13ED1C are output. C



A

B

C