| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B153A | GVIF Disconnected (from Extension Module to H/U) | GVIF disconnected (from navigation ECU to radio receiver assembly) | ·
Harness or connector ·
Navigation ECU ·
Radio receiver assembly |
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Clear the DTCs.
Press the "MAP" switch and check for DTCs.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Disconnect the d5 radio receiver assembly connector.
| *a | Front view of wire harness connector
(to Radio Receiver Assembly) |
| *b | Front view of wire harness connector
(to Navigation ECU) |
Disconnect the d1 navigation ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| d5-1 (GV2-) - d1-1 (GVO-) | Always | Below 1 Ω |
| d5-2 (GV2+) - d1-2 (GVO+) | Always | Below 1 Ω |
| d5-3 (GVG2) - d1-3 (GVG1) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the navigation ECU with a new or known good one.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION ECU>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Press the "MAP" switch and check for DTCs.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG