Home › Engine / Hybrid System › 2GR-FKS (ENGINE CONTROL) › HEATED OXYGEN SENSOR › from 2020.11
RM37A0E _51 Engine / Hybrid System _086849 2GR-FKS ENGINE CONTROL _0418449 HEATED OXYGEN SENSOR A

2GR-FKS ENGINE CONTROL  HEATED OXYGEN SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during heated oxygen sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of heated oxygen sensor

·

Gas leak from exhaust system is repaired


Perform Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 58166A 1.REMOVE FRONT FLOOR COVER LH (for Bank 1 2WD)

Hide 89465A 2.REMOVE HEATED OXYGEN SENSOR (for Bank 1 2WD)

a.
A455883

Disconnect the heated oxygen sensor connector.


b.

Disengage the 2 wire harness clamps.


c.
A454813N01
0.969,1.198 0.969,0.823 0.969,0.823 1.26,0.823 true 0.844,1.208 1.302,1.406 0.458,0.198 10 true SST

Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

SST
09224-00012  

NOTICE:

If the heated oxygen sensor has been struck or dropped, replace it.



Hide 17410 3.REMOVE FRONT EXHAUST PIPE ASSEMBLY

Hide 89465A 4.REMOVE HEATED OXYGEN SENSOR (for Bank 1 AWD)

a.
A454815N01
1.604,1.031 2.031,1.031 true 2.073,0.948 2.531,1.146 0.458,0.198 10 true SST

Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

SST
09224-00012  

NOTICE:

If the heated oxygen sensor has been struck or dropped, replace it.



Hide 89465 5.REMOVE HEATED OXYGEN SENSOR (for Bank 2)

a.
A454817N01
2.354,1.365 2.5,0.719 2.5,0.719 2.677,0.719 true 2.719,0.625 3.177,0.823 0.458,0.198 10 false SST

Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

SST
09224-00012  

NOTICE:

If the heated oxygen sensor has been struck or dropped, replace it.