The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear television camera assembly removal/installation are shown below.
67848E
1.REMOVE BACK DOOR SERVICE HOLE COVER LH
67847
2.REMOVE BACK DOOR SERVICE HOLE COVER RH
Use the same procedure as for the LH side.
64780A
3.REMOVE BACK DOOR TRIM PANEL ASSEMBLY
4.REMOVE TELEVISION CAMERA ASSEMBLY WITH NOZZLE (w/o Digital Inner Mirror)
Disconnect the washer hose.
Use a container to collect the windshield washer fluid.
Disconnect the connector.
Remove the 2 nuts.
|
Remove in this Direction |
Disengage the 2 claws and remove the television camera assembly with nozzle as shown in the illustration.
5.REMOVE TELEVISION CAMERA ASSEMBLY WITH NOZZLE (w/ Digital Inner Mirror)
Disconnect the 2 washer hoses.
Use a container to collect the windshield washer fluid.
Disconnect the 2 connectors.
Remove the 2 nuts.
|
Remove in this Direction |
Disengage the 2 claws and remove the television camera assembly with nozzle as shown in the illustration.
867F0
6.REMOVE CAMERA CLEANER NOZZLE ASSEMBLY
867F0
7.REMOVE CAMERA CLEANER NOZZLE ASSEMBLY (w/ Digital Inner Mirror)
867C0
8.REMOVE INNER MIRROR CAMERA ASSEMBLY (w/ Digital Inner Mirror)
86790D
9.REMOVE REAR TELEVISION CAMERA ASSEMBLY