1.INSPECT AND ADJUST BRAKE PEDAL HEIGHT
89510D
2.INSTALL BRAKE PEDAL STROKE SENSOR ASSEMBLY
If the brake pedal stroke sensor assembly has been dropped, replace the brake pedal stroke sensor assembly with a new one.
| *a | Brake Pedal Stroke Sensor Assembly Lever |
| *b | Brake Pedal Groove |
| *c | Brake Pedal Stroke Sensor Assembly Lever Set Pin |
When installing a new brake pedal stroke sensor assembly:
Do not break the brake pedal stroke sensor assembly lever set pin before installing the brake pedal stroke sensor assembly with the 2 nuts.
Install a new brake pedal stroke sensor assembly to the brake pedal support assembly with the 2 nuts.
Engage the brake pedal stroke sensor assembly lever with the brake pedal groove.
Check that there is no foreign matter attached to the contact surface of the brake pedal stroke sensor assembly.
Check that the tip of the brake pedal stroke sensor assembly lever is protruding from the brake pedal groove.
Fully tighten the 2 nuts.
Connect the connector.
Firmly depress the brake pedal to break the brake pedal stroke sensor assembly lever set pin.
Remove the broken lever set pin.
| *a | Brake Pedal Stroke Sensor Assembly Lever |
| *b | Brake Pedal Groove |
When reusing the brake pedal stroke sensor assembly:
Install the brake pedal stroke sensor assembly to the brake pedal support assembly and temporarily tighten the 2 nuts.
Engage the brake pedal stroke sensor assembly lever with the brake pedal groove.
Check that there is no foreign matter attached to the contact surface of the brake pedal stroke sensor assembly.
Check that the tip of the brake pedal stroke sensor assembly lever is protruding from the brake pedal groove.
The nuts will be fully tightened when adjusting the brake pedal stroke sensor assembly.
Connect the connector.
3.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>A25A-FXS, A25B-FXS AUXILIARY BATTERY>INSTALLATION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
89510D
4.ADJUST BRAKE PEDAL STROKE SENSOR ASSEMBLY
When the brake pedal stroke sensor assembly is being reused, perform the following procedure to adjust it.
Do not depress the brake pedal after turning the ignition switch to ON.
Read the stroke sensor value in the Data List, and turn the brake pedal stroke sensor assembly slowly to the right or left to adjust the output voltage so that it is within the following range.
| Tester Display |
|---|
| Stroke Sensor |
0.8 to 1.2 V
Fully tighten the 2 nuts.
5.PERFORM INITIALIZATION AND CALIBRATION
for Electronically Controlled Brake System: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>UTILITY
6. CHECK AND CLEAR DTC